Where is the resister on a Mercedes Benz fan?

Just to the left of the blower motor, an electrical connector connected to a flat 1-inch-by-2-inch plate can be seen. This is the blower motor resister, which controls the fan speeds. Disconnect the multi-wire connector from the blower motor resister next to the blower motor. Start the car and turn the air conditioning on.

Where is the regulator on a Mercedes fan blower?

The Mercedes Benz fan blower motor regulator is a series of resisters in a printed circuit board about 2-inches square located right next to the blower motor.

Why is my radiator fan not working properly?

The fan clutch is the assembly that holds the radiator fan to the engine and makes it turn. If this burns out or fails, you’ll need to replace it. There are springs within the fan clutch that can wear out or corrode over the years. If everything else seems to be fine, the fan clutch is the most likely cause of radiator fan failure.

Why do I need to replace my radiator fan clutch?

Fan Clutch The fan clutch is the assembly that holds the radiator fan to the engine and makes it turn. If this burns out or fails, you’ll need to replace it. There are springs within the fan clutch that can wear out or corrode over the years.

Where is the cooling fan on a Mercedes E550?

Mercedes E550 Cooling Fan Connector Location – Passenger side, behind the fan. Press the connector and pull it to disconnect it. Remove two U clips at each top corner of the radiator. These clips can be removed by prying them up with a screwdriver. Slide the radiator colling fan up.

Where is the radiator connector on a Mercedes?

It is clipped to the bottom of the top radiator bracket. Locate the electrical connector on the back of the cooling fan. Mercedes E550 Cooling Fan Connector Location – Passenger side, behind the fan. Press the connector and pull it to disconnect it. Remove two U clips at each top corner of the radiator.

What does it mean when your radiator fan is not working?

This is what we call a blown fuse. A blown fuse is no big deal, and changing one does not cost a lot of money. If your car’s radiator fan is non-functional, check your car’s user manual and locate the fuse for the radiator fan controller or the fan.

How long does it take to replace a Mercedes Benz radiator?

These instructions should help you replace the radiator on Mercedes-Benz models such as C, S, ML, GL, GLK, GLE, GLS, etc. Replacing the radiator on a Mercedes-Benz is easy and takes about two hours. Below is a list of parts and tools that you will need to change the radiator on most Mercedes-Benz vehicles. Between 3 and 4 gallons.

Why are the cooling fans not working on my car?

1. Engine running hot 2. Cooling fans do not function 3. Cooling fans stay on at all times Average rating from 129,472 customers who received a Vehicle Engine Cooling Inspection. Most modern vehicles use electric cooling fans to help pull air through the radiator so that it can keep the engine cool.

How long does a car fan run after you turn off the engine?

Your car fan will run for a few minutes after you turn off the car then turn off. This is normal in many vehicles, such as BMW or Mercedes-Benz. The radiator fan may run up to five minutes and sometimes longer. Unless there is an electrical issue, it may stay on all the time until it drains the battery.

What are the symptoms of a bad cooling fan relay?

1. Engine running hot One of the first symptoms commonly associated with a bad or failing cooling fan relay is an engine that runs hot or overheats. If you notice that your engine is running at higher temperatures than normal, that may be a sign that the relay is not functioning properly.

Why does my car fan keep running after I shut it off?

It is so the car won’t heat soak and blow coolant out the pressure release. Your habit of pulling the fuse may have arced the contacts on the fan relay causing it to weld itself open. Replacing that relay should fix it but it still may run the fan after you shut the car off.

What to do if your Mercedes Benz fan is stuck?

Not hard to do, just drop the blower motor and replace the regulator. The hardest part is positioning your self under the dash and looking upwards to locate the mounting screws. Hi Paul, just wondering if you found a solution to your stuck fan.

What to do if your a / C fan won’t turn off?

At the room thermostat: the FAN-AUTO-OFF or FAN ON/OFF switch on the room thermostat should be checked. The fan control should be set to AUTO. You can try turning the switch to OFF too. Other snafus such as a shorted thermostat wire can also cause the A/C or warm air furnace fan to run continuously. at THERMOSTAT WON’T TURN OFF. 2.

What should I do if my radiator fan stops running?

If the fan doesn’t stop running, plug that sensor back in and unplug the coolant temp sensor on the thermostat housing. If the fan stops running, replace that sensor. If the fan still runs after unplugging both sensors, then problem might be with radiator fan control module located behind the glove box.

Why is my Mercedes air conditioner not working?

Your Mercedes vehicle will flash a host of service lights to inform you when something might be damaged inside the car. If the air conditioner unit is not running normally or is only blowing out warm air, it may be a temporary fault. Sometimes the unit isn’t actually damaged, and resetting your climate control unit …

How to test a Mercedes Benz fan blower motor regulator?

This is the blower motor resister, which controls the fan speeds. Disconnect the multi-wire connector from the blower motor resister next to the blower motor. Start the car and turn the air conditioning on. Test the connector for power at the terminals in the connector using the voltmeter. If there is power, reinstall the connector to the resister.

How do you defrost a Mercedes Benz without cranking the engine?

Insert the key into the Mercedes ignition and turn the ignition cylinder to the “2” position. This is as far as the cylinder will go without cranking the engine. Press and hold the defrost and recirculated air buttons simultaneously.

What to do if your Mercedes heater fan is not working?

Look at the 30A inline strip fuse (pop the cover fm holder), drivers side near hood alarm switch and strut mount. Mine just failed a few days ago, cracked in half fm fatigue. The fan speed controller is hooked up to the speed sensor in your speedometer.

What causes a heater fan to stop working?

What else would stop working if the OVP is bad or what else causes the heater fan to not work. Its too cold now to use the car without heat. Assuming all your fuses are good, either the blower motor is toast or the blower motor regulator has gone. There is a nice R/R link for the blower motor in the DIY section.

Why is my fan speed controller not working?

Mine just failed a few days ago, cracked in half fm fatigue. The fan speed controller is hooked up to the speed sensor in your speedometer. If you are getting air movement at hwy speed but no fan at idle I would suspect that the speed controller is likely faulty.

What should the voltage be on a Mercedes blower fan?

Follow them to a terminal block located on the firewall near the power brake vacuum booster. One should be ground/earth. One should have +12V. The last one should have around +6V; the exact voltage will vary depending on the fan switch setting. If any of these are wrong, check for connection problems.

Why is my Mercedes air conditioning not working?

All Mercedes cars have a series of service lights that there is something wrong with an internal component or system. However, there might not be any damage in the AC unit when it is blowing warm air or not running properly. It could be a temporary fault and a reset is likely to be enough to restore the normal function.

What to do if your Mercedes heater blower is not working?

My blower motor was fixed in with 3 posidrive screws. Had to use a stubby screwdriver on one of them too due to a serious lack of room. Check first before just pulling it out Rooty.

What causes a Mercedes-Benz SL500 heater to not work?

Find the most common driver-reported problems that are to blame when a Mercedes-Benz SL500 has heater problems. Bad Switch/Blower Motor Resistor Assembly May C… Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower…

How to troubleshoot your Mercedes Benz air conditioner?

Identify the location of your compressor. Look at the pullyer and you should be able to see if it spining or not. The engine running turn the A/C on max cool, set fans high, and make sure that the clutch is engaging on the compressor. The pulley spins any time the engine is running. The center part of the A/C pulley only engages when the A/C is on.

Why does my Mercedes Benz fan keep running?

Automotive information based around Mercedes-Benz information and repair assistance along with other makes and models. No matter what car you own or need help with, my tips and tricks and teachings can help you along the way. An error occurred while retrieving sharing information. Please try again later.

What should I do if my Mercedes engine stops working?

Be aware that if you reset the unit and it again stops working, you need to take the vehicle in to the dealership for repairs. Insert the key into the Mercedes ignition and turn the ignition cylinder to the “2” position.

Why does my Mercedes air conditioner keep blowing hot air?

In many models, the AC keeps blowing hot air even after recharging the coolant. It is a frustrating problem, especially during the summer, when it is almost impossible to drive a car without the AC on. A Mercedes air conditioning reset is a possible solution. Do you know how to do it? Is there any other way to fix the glitch?

How to troubleshoot your Mercedes medic air conditioner?

Turn the A/C ON. If you have an Economy button make sure that is off. Make sure fan is on HIGH, temperature selector is turned all the way to COLD, and that the A/C and recirculate light indicators are on. Set the temperature to cold, the lowest setting. Set the cooling fans on high on the climate control.

Why does my air conditioner spin when the engine is running?

The pulley spins any time the engine is running. The center part of the A/C pulley only engages when the A/C is on. If the clutch is engaging and disengaging rapidly, the refrigerant may be low. Locate the Low Pressure A/C recharge port.

What happens when a heater motor resistor fails?

If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored. 2. Blower motor does not work on certain settings

Why does my blower resistor keep going bad?

Trent, one of the biggest reasons for blower motor resistors to have shorten life is actually because of faulty blower motor drawing too many amps, some times melting wires/plugs, heating up resistors shortening their life. Many Dodge forums tell of this problem.

Why is my blower motor resistor not working?

If there is power indicated on high blower speed, but not low or mid range, the problem is the blower resistor. Test for ground at the blower motor if there is power indicated at all ranges, but the motor does not function.

Why does my blower fan only work on one speed?

by Lee Sallings. The most common symptom of a faulty blower motor resistor is a blower fan that only works on one speed, usually high. This can be annoying, but troubleshooting is easy. If you start at the blower motor, and check resistance in the circuit, you will find the problem in no time.

Why is my car AC fan not working?

Another reason why your car AC fan is not working could be due to your cabin air filter. Cabin air filters serve as a filter to the outside air coming into your car to make sure it is clean and not filled with contaminants. However, if this air filter isn’t changed,…

What happens when Mercedes Benz air suspension stops working?

When they stop working the air suspension control unit may no longer be able to recognize the height of the car. Your Mercedes-Benz will greet you with a warning message on the dash related to the airmatic failure. The car height may be correct and the car still rides fine, it’s just that the computer doesn’t know that.

What should the fuse look like on Mercedes Benz air suspension?

Procedures are similar for other Mercedes-Benz with air suspension, but the location of the relay and fuse may change. In this S-Class W220, the air compressor motor /pump is protected by Fuse 32, which is a MaxiFuse 40 Amp. Here is what a good fuse should look like.

The Mercedes Benz fan blower motor regulator is a series of resisters in a printed circuit board about 2-inches square located right next to the blower motor.

Why does my Mercedes E320 AC not reset?

For example, if you want to know about Mercedes E320 AC reset, it is better to check the manual and follow the manufacturer’s recommendations. If a Mercedes air condition reset does not work, these following reasons could be causing the trouble: When the AC is releasing hot air, the possible reason could be a defect in the damper.

How does a Mercedes Benz fan blower work?

The Mercedes has a series of sensors that, working in concert with a computer, maintain a constant climate in response to the settings on the console. These sensors even sense when the window is down or the door is open and increase the fan speed as necessary to maintain a constant temperature within the car.

Why is my C230 Komp heater not working?

C230 Komp blower has been off and on since last year, and only working on 5 when it did. Worked fine over summer. Now that it is cold, it stopped for the most part. Read the threads here….pulled cover off from under passenger foot well and access the blower motor and wiring. Wiggled wires and checked connections and that did the trick.

Where is the fan on a 1999 V220 Ambiente?

Click to expand… I have a 1999 V220 Ambiente with same problem, fan sometimes works and comes on over speed bumps. I have located the motor, visible behind left hand dash vent, but can’t get at it to remove. Even when working it’s not powerful so needs replacing or new brushes, just need to remove it.

Navigation