Where is the reset button on an air compressor?
You can see one of them on the end of the electric motor in the image below. It may be a small red button on the shroud of the compressor, it may be a button on the end of the motor if that is visible on your compressor, and I have seen them on the side of the motor at the shaft end, on some compressor motors.
What to do when your air compressor does not start?
When my air compressor will not start I always check the tank gauge to see what the pressure reading is in the tank.
Where is the ON / OFF switch on an air compressor?
The pressure switch on the right incorporates an ON/OFF lever on the right side as well. When the reciprocating air compressor reaches the cut out pressure setting the power supply to the compressor motor stops, and as a result, the compressor pump stops.
Where can I find an air compressor manual?
However, finding a manual for a specific model can lead you on an Indiana Jones treasure hunt. Our air compressor manual library might not be as old as Raiders of the Lost Ark, but it expands everyday.
How to restart an AC compressor [ step by step guide ]?
How to Restart an AC Compressor Step 1. Step 2. Locate the breakers for the air conditioning and heating circuits in the main circuit breaker box. Usually these… Step 3. Pull the heating and air conditioning circuit breakers to the “Off” position. Step 4. Adjust the temperature setting on
Where is the thermal reset button on an air compressor?
The locations of this important piece of equipment on the air compressor sure do vary. Regardless of where the compressor thermal reset button is on your compressor – on the motor or on the shroud of the compressor – it’s purpose is to cut the power to the motor in the event that the motor itself gets too hot.
However, finding a manual for a specific model can lead you on an Indiana Jones treasure hunt. Our air compressor manual library might not be as old as Raiders of the Lost Ark, but it expands everyday.
How long does the compressor reset button run for?
It runs for 30 seconds and then pops the reset button. The power supply is 12ga. solid wire on a 20 amp breaker less than 2 feet from the recep to the breaker, It does not run long enough to get hot and it is fairly new.