Where is the oil filter located on a BMW?
You need some tools before you start the oil change process. Make sure you have handy an oil pan, socket and socket wrenches, and a flat head screwdriver. If you have a six cylinder engine, the oil filter housing is located in the front of the engine bay, near the intake manifold. I’m using the N52, N54 and M54 engines as examples.
How to do an oil change on a BMW 320i?
Allow engine oil to drain until it stops dripping. Keep an eye on oil as it drains. The stream of oil will move and there is a chance it will miss the drain pan. Install oil drain plug with new sealing washer and torque to 25 Nm (18 ft-lb). Close oil drain plug access door. Remove drain pan from below vehicle.
How do you change the oil in a BMW M3?
To remove the oil filter, you need a 36mm socket. When you remove it, make sure you have something below to catch the oil that will dribble out when you remove the filter. Once done, it’s time to move under the car. Under the E90/E92/E93 M3 locate the two drain plugs fore and aft under the motor. They require a 6mm hex to remove.
Where is the oil drain plug on a BMW E90?
This photo shows the oil drain plug door location on all-wheel drive models. (green arrow) Place drain pan centered below oil drain plug. Using a 17mm socket, remove oil drain plug. Allow engine oil to drain until it stops dripping. Keep an eye on oil as it drains.
How do you replace the oil filter on a BMW E90?
Replace the oil filter and oil filter o-rings You will notice that the oil filter sits inside of the housing, which has a pole in the middle of it that sticks out. The filter should be firmly set in there, but should remove easily by simply pulling upwards on it. Pull upwards and pull the filter out.
How do you change the oil in a BMW?
Use a BMW oil filter wrench to remove the oil filter. Ideally, you want to use the BMW oil filter tool, but oil filter pliers will work as well. Replace o rings on the oil filter. The O rings on the oil filter housing should be changed every time you change the oil filter.
When to reset the oil change light on the BMW 328i 2000?
The Oil Change Light Reset BMW 328i 2000 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the BMW 328i 2000. Follow the steps below to reset the oil life monitor after each oil change.
How to change transmission fluid in BMW 320i?
Using a T40 Torx bit, remove the twenty-four transmission pan screws. By leaving the screws opposite of the drain plug in place, you can drop the drain lower to more effectively drain the oil.