Where is the hard drive in Ricoh copier?

Where is the hard drive in Ricoh copier?

The hard disk drive is installed in the slot shown in the illustration below. Insert the protrusion on the front end of the hard disk board into the notch on the back panel of the controller board. Be sure to set the hard disk board parallel with the controller board.

How do you wipe a Ricoh hard drive?

1. Disconnect communication cables connected to the printer.
2. Press the [Menu] key.
3. Press the [ ] or [ ] key to display [Maintenance], and then press the [
4. Press the [ ] or [ ] key to display [Erase All Mem.],
5. Press the [ ] or [ ] key to display [Erase Method], and then press the [
6. Select the method of erasing the data.

How do you remove the harddrive from a Canon copier?

Push and open the right cover of the machine. Open the front cover of the Removable HDD Kit. If the front cover is locked, unlock the front cover. Hold the handle on the hard disk holder and remove the holder.

How do I get rid of errors on my Ricoh printer?

General Troubleshooting Steps to Fix Ricoh Not Printing Error

1. Firstly review any error codes reported by the machine.
2. Then power cycle the copier by turning off the machine, wait for approximately one minute and then turn on the machine again.

How do I clear memory on my copy machine?

Turn off the printer and unplug it from the electrical outlet. Leave the printer unplugged for a minute before reconnecting the power to make sure the memory completely loses power. After plugging the printer in and turning it on, wait until the printer finishes its startup sequence before sending a new print job.

Do Ricoh copiers have hard drives?

There’s nothing special about handling the HDD’s in a Ricoh copier. Just remove the HDD, perform the wipe to the required level as dictated by the customer policy, reinstall. If you want to be really anal about it you could format it manually once reinstalled but if it is simply a lease return I wouldn’t bother.

How do you remove a hard drive from a copier?

How to Remove a Hard Drive on a Xerox Workcenter 5655

1. Step 1: Unscrew the Pins. Unscrew the pins that the back of the machine for the tray underneath the scanning station.
2. Step 2: Pull out the Tray and Remove Drive. Pull the tray out.
3. Step 3: There may be multiple drives for other models.

How do I remove the hard drive from my printer?

Removing a printer hard disk

1. Access the controller board.
2. Unplug the printer hard disk interface cable from the controller board, leaving the cable attached to the printer hard disk.
3. Remove the screws holding the printer hard disk in place.
4. Remove the printer hard disk.
5. Set aside the printer hard disk.

How do you remove a hard drive from a printer?