Where is the ground terminal on a 3000GT?
The service manual for the 1992-1996 3000GT (p. 13A-50) does identify the correct ground terminal. For the correct identification of all terminals in the 1991-1993 diagnostic connector, see my web page 2-diagconn.htm . For 1994 and 1995 models, the diagnostic port was re-located to under dash knee protector near the driver’s right leg.
How can I find out if my battery is draining?
Replace the fuse and disconnect each lamp, heater, or electrical device one at a time. Flip all of the switches that correspond to the components as well. Watch for the reading on the multimeter to drop to find out which component is causing the drain. For instance, say the offending fuse controls the power antenna as well as the radio.
How to get rid of negative battery drain?
Remove the negative battery cable from the negative battery terminal. Find the negative cable, which will be marked with a minus sign (-) and may have a black cover over it. Remove the cover, if applicable, and use a wrench to unbolt the negative cable from the terminal.
What does it mean when your battery drains overnight?
Why the Battery Drains Overnight A slow battery drain when everything is off is called a parasitic power loss. This happens when something – a glovebox light, an amplifier, any electrical component – is pulling power from the battery when it shouldn’t.
Remove the negative battery cable from the negative battery terminal. Find the negative cable, which will be marked with a minus sign (-) and may have a black cover over it. Remove the cover, if applicable, and use a wrench to unbolt the negative cable from the terminal.
Replace the fuse and disconnect each lamp, heater, or electrical device one at a time. Flip all of the switches that correspond to the components as well. Watch for the reading on the multimeter to drop to find out which component is causing the drain. For instance, say the offending fuse controls the power antenna as well as the radio.
How to find the cause of parasitic battery drain?
Luckily, you can usually find the cause of a parasitic draw yourself. Start by connecting a digital multimeter to the negative battery terminal of your vehicle. Then, remove the fuses one at a time while watching for changes in the multimeter’s reading.
Why does my OnStar battery drain so much?
Community Answer In older vehicles running analog Onstar, the system will drain the battery because it is constantly looking for a signal. Onstar no longer offers an analog signal, only digital.
The service manual for the 1992-1996 3000GT (p. 13A-50) does identify the correct ground terminal. For the correct identification of all terminals in the 1991-1993 diagnostic connector, see my web page 2-diagconn.htm . For 1994 and 1995 models, the diagnostic port was re-located to under dash knee protector near the driver’s right leg.
What are the safety precautions before using ScanSnap?
Make sure that you read ” Safety Precautions ” before using the ScanSnap. Make sure that you read ” Safety Precautions ” before using the ScanSnap. Make sure that you read ” Safety Precautions ” before using the ScanSnap. What is a Profile?
What kind of scanner is the snap on mt2500?
Snap On Mt2500 Scanner. Snap On Verdict D7, with Wireless Module, Multimeter, Hard Case. Like new Snap On Verdict D7, with Wireless Module, Multimeter, Hard Case, Charging Dock.
Are there any blue tooth snap on scanners left?
MATCO OR LAUNCH 3.0 SCANNER BLUE TOOTH MODEL DS: 601 WITH ACTIVATION CARD! Only 1 left! LIKE NEW Snap On Pass Thru Pro IV IN GREAT CONDITION!!