Where is the gearshift on a Honda Rubicon?
Put the Rubicon into the neutral using the gearshift located on the side of the ATV. Hold the “Up” and the “Down” shift buttons down at the same time and then release them.
How can I troubleshoot my Honda Rubicon ATV?
Put the Rubicon into the neutral using the gearshift located on the side of the ATV. Hold the “Up” and the “Down” shift buttons down at the same time and then release them. Press both of the buttons down again and hold them for about two seconds. Look at the ATV’s display for a troubleshooting code.
Are there any problems with the Rubicon 520?
I just bought a 520 rubicon it left me 2 times with that same problem. It seems when it is cold weather it starts with the shifting problem. called the dealer and will take 4 weeks before they can look at it. I did buy the extended warranty. should have gone back to polaris
Why does my Honda Rubicon not start up?
Make sure that you have enough fuel to start the ATV. Fill the gas tank with fresh fuel if you are on empty. Make sure that you are not using fuel that has been sitting in a container exposed to the elements. If condensation has entered the fuel container the water in the fuel could cause misfires in the engine.
Why is my Honda Rubicon 500 not shifting?
Two of us just purchased 2 new 2016 Rubicon 500 with the automatic and manual shifting. Both are showing the same problem. If I use the manual model to shift up and down it sometime settles between gears lets say second and third and will not let me shift up or down.
Can a Honda Rubicon 520 shift in ESP mode?
Started off working great in auto. Started using it in ESP mode and it was shifting good. After approximately 15-20 mins of riding it failed with a dash on the display and felt like it was stuck in 2nd or 3rd gear. Dash flashed 2 slow and two fast flashes. Turned key off and back on and could here it shift back into Neutral.
Why is my shift button not working on my Honda?
You can hear the shift motor trying to make the shift when you press a shift button <->, but no shift occurs and, at times, you receive a – – – display. The problem occurs even more often when it is cold outside. Fortunately, the answer/fix to the problem is really very easy!
Why are my shift gears not working properly?
The problem is caused by very heavy, stiff, gummy grease that was installed in the shift motor gears at the factory. Once that grease is removed and replaced with a different grease, you’ll be back to shifting normally! So, here’s how you replace that grease: Remove the shift motor and gears (all one piece) from the lower front of your engine.