Where is the crankshaft position sensor located on a 2010 Jeep Patriot?
The Crankshaft Position Sensor is in the rear of the engine block near the transmission.
What is the p0335 code on a Jeep Patriot?
I pulled a P0335 code which is the Crankshaft position sensor and went ahead and replaced it. That was the only error code involved. After replacing the Jeep still will not start. Does anybody have any thoughts on this?
What does crankshaft position sensor on Jeep Patriot do?
The Jeep Patriot utilizes a crankshaft position sensor in order to regulate the engine timing. This sensor uses a reluctor to gauge the position of the crank. When the Patriot’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code.
How is crankshaft position determined on a p0335 Ford?
As this reluctor ring passes in front of the CKP sensor, the magnetic field created by the CKP sensor is interrupted and this creates a square wave voltage signal that the PCM interprets as crankshaft position. If the PCM detects that there are no crankshaft pulses or if it sees a problem with the pulses on the output circuit, P0335 will set.
What’s the difference between p0335 and p0385?
This code is basically identical to P0385. This code P0335 refers to Crankshaft Posistion Sensor “A”, whereas P0385 refers to Crankshaft Position Sensor “B”. Other crank sensor codes include P0016, P0017, P0018, P0019, P0335, P0336, P0337, P0338, P0339, P0385, P0386, P0387, P0388, and P0389. my truck is not getting any throttle…
What does trouble code p0335 mean on Jeep Patriot?
When the Patriot’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code. Depending on the model year and engine of any vehicle the job of the crankshaft sensor is going to change.It’s either going to provide info to the ECM to keep the vehicle from misfiring.
The Jeep Patriot utilizes a crankshaft position sensor in order to regulate the engine timing. This sensor uses a reluctor to gauge the position of the crank. When the Patriot’s ECM determines that there is an issue with the signal coming from this sensor, it’ll throw the P0335 trouble code.
What’s the P0300 code on a Jeep Patriot?
Though with the additional codes it’s probably not the plugs (as I would imagine one would go before the rest and give you a p030x code, the x being 1-4 to designate the cyl. misfiring). Check the harness for the crank sensor too, make sure it didn’t get damaged or anything.
Why is the p0335 thrown on the road?
The crankshaft sensor is often the reason that P0335 is thrown. They aren’t very expensive, but they can be difficult to get to in order to service them. If you think you’re up to the challenge (and know how to use a volt meter) this guide from doityourself.com will show you exactly how to test the sensor.