Where is the bell housing located?
This housing is bolted to the engine block and derives its name from the bell-like shape that its internal components necessitate. The starter motor is usually mounted here, and engages with a ring gear on the flywheel. On the opposite end to the engine is usually bolted to the gearbox.
Are all Chevrolet Bellhousings the same?
All Chevy V6 and V8 engines continue to use the same block-to-bellhousing pattern as introduced in 1955. This includes Generation I, II and III engines. However, the Jeep bellhousings from these engines (1980-1982) rarely fit the full-size clutches of the V6/V8 engines. Flywheels do not interchange.
How do I know if I have a 4L60E?
4L60E One Piece Case Identification: 93-97
- Four bolts connect the tail shaft (or transfer case) to the transmission.
- The vehicle speed sensor changed locations during the production run.
- There is an information sticker on top of the bell housing at the very top of the transmission.
Who makes quick time Bellhousing?
Quicktime Bellhousings Products – Tick Performance, Inc.
How can you tell the difference between a 4L60 and a 4l80 transmission?
The 4L80E can be told apart from the 4L60E by looking at their transmission fluid pan. This is because the 4L80E has a pan that is oval in shape whereas a rectangular pan is featured by the 4L60E. Another disparity between both devices is the number of bolts used to secure the transmission to the engine.
What are the bellhousing numbers on a Chevy truck?
Some common side mount, V8 bellhousing casting numbers for trucks are, 3738373, 3765710, 3733365, 3815891, and 3925505. There may be others. All those numbers fit the 10 1/2″ or 11″ clutch and the 168 tooth flywheel. There are three common starter bolt patterns for the V8 or late six. The earlier ones bolt to the bellhousing with three bolts.
Where is the bellhousing on a GM car?
A rear wheel drive bellhousing is displayed at right. Nearly identical to the GM small corporate/metric pattern, except that the starter is located between the cylinder banks, and the lower right bolt hole is moved outward by roughly one inch. Being nearly identical, it too has the distinctive odd-sided hexagonal shape.
Can you use aluminum bellhousing on a Chevy truck?
The aluminum bellhousing will not work without major cutting on the cross member. The only difference in the cast iron ones seems to be which starter is required. Some common side mount, V8 bellhousing casting numbers for trucks are, 3738373, 3765710, 3733365, 3815891, and 3925505. There may be others.
What kind of bellhousing do you need for a V8 truck?
If you are putting a V8 or late six in your truck, you will need a V8 angled side mount cast iron truck bellhousing from 1955 to 1968. They all fit the 168 tooth flywheel. The aluminum bellhousing will not work without major cutting on the cross member.