Where is cooling fan relay located?

The cooling fan relay is normally located in either the underhood fuse and relay center or mounted to the electric fan assembly behind the radiator. To replace the cooling fan relay, there are two methods that we will cover for the positions mentioned above.

Why do you need a cooling fan relay?

Average rating from 29 customers who received a Cooling Fan Relay Replacement. Most modern vehicles use electric cooling fans to help pull air through the radiator so that it can keep the engine cool. Most cooling fans use electric motors that have a moderate to high current draw, and as a result are commonly controlled using relays.

How does the mode control relay work on a radiator?

The relay (s) are used to control the high current flow to power the cooling fan motors. When minimum cooling is required, the BCM will command the PCM to energize cooling fan relay #1 and since both fans are connected in series through the Mode Control relay, both fans will operate at low speed.

Can a bad fan relay cause an engine to overheat?

However, a bad cooling fan relay isn’t the only culprit for excessively high engine temperatures. Many other issues can cause the engine to run hot or overheat. Rather than uncommonly high engine temps, the driver may notice that the cooling fans have stopped running.

Where are the relays for the engine cooling fan?

Where is the cooling fan relay switch located?

The cooling fan relay is located in the left front corner of the engine compartment, just in front of the radiator coolant reservoir. Circuit protection is provided by a 20 amp fuse labeled COOLING FAN in the fuse panel to the left of the steering column. When engine temperature is below 90°C (194°F), the cooling fan switch is closed and the relay contacts are held open by the magnetism produced in the relay coil.

Where is fan relay switch located?

Re: Where is the fan relay switch located in a 1996… There is a relay located in the power distribution center. This should be located under the hood, either on the fender wells or near the back of the engine compartment. It will be label power distribution.

Where is the blower motor fuse and relay located?

The blower relay is located near the front of the fuse block and is labeled “Blower.”. Inspect the center of the relay. If the metal rod inside is broken, the relay will need to be replaced.

What does a cooling fan relay do on a car?

A cooling fan relay is used on vehicles that have an electrical fan to cool the engine. The function of the cooling fan relay is to convert a low voltage signal from either the electronic control module (ECM) or a thermostatically controlled sensor.

What happens when the fan relay does not work?

By using a lower voltage signal to control the relay, there is less stress on the rest of the wiring and charging system. When the fan relay does not work, then the proper signal will not be received and the fan cannot cool the system down.

How do you remove a fan relay cover?

Step 2: Remove the fuse/relay box cover. Remove the cover from the top of the underhood fuse/relay box. This will be accomplished by removing or releasing any combination of retaining clips or fasteners. Step 3: Identify the cooling fan relay.

Where are the cooling fan relays on a radiator?

The electric cooling fan (s) are controlled by the Body Control Module (BCM) which enables the fans through the PCM. The PCM enables the ground path for the three cooling fan relays. The relay (s) are used to control the high current flow to power the cooling fan motors.

What to do if your cooling fan relay is failing?

For this reason, if you suspect that your cooling fan, or relay, may possibly be having issues, have the vehicle diagnosed by a professional technician, such as one from YourMechanic. They will be able to look over your vehicle and replace your cooling fan relay if necessary.

Why is my radiator cooling fan not working?

The radiator cooling fans will not come and it causes overheating. It may be the fan relay or switch (whatever it is called). My problem is trying to locate it. Is it near the battery or where is it so I can install the one sold to me by Autozone automotive parts store.

Why does my Jeep Grand Cherokee Fan quit working?

In this one we take a stab at permanently fixing a common issue with the 1999-2004 Jeep Grand Cherokee. The electric cooling fan will quit working, and your jeep will overheat, due to a failure in the electronic fan control relay. This is a heat related failure and I add a large heat sink and relocate the relay to try and avoid further issues.

How much does it cost to repair a jeep fan relay?

Most auto repair shops charge between $75 and $150 per hour. When is the code detected? With the key on or engine running, system voltage over 10v, fan relay commanded on, the Powertrain Control Module ( PCM) detects a shorted or open condition in the relay control circuit.

Where are the fan relays located?

The fan relays are located in the plastic box under the hood , near the battery on top of inner fender well. The box lid has fuse and relay description printed on it.

Is it necessary to replace the cooling fan relay?

Replacing your cooling fan relay is a vital repair for keeping your car running properly. If at any point you feel you could use a hand with replacing a cooling fan relay, have one of YourMechanic’s certified technicians come to your home of place of business and perform the repairs for you.

Is there a way to test a radiator fan?

You can test the electrical radiator fans by taking a wire from the car battery, unplug the radiator fan connector, and put 12v+ and ground into the connector. This is the fastest and easiest way to test your radiator fans. Because the radiator fan is often drawing so much power, there is often a relay that is powering the coolant fan.

What are the symptoms of a bad cooling fan relay?

1. Engine running hot One of the first symptoms commonly associated with a bad or failing cooling fan relay is an engine that runs hot or overheats. If you notice that your engine is running at higher temperatures than normal, that may be a sign that the relay is not functioning properly.

Where are the fuses on a Jeep Cherokee?

Jeep Cherokee (XJ) 1997 – 2001 Fuse & Relay Information FUSE NUMBER FUSE CURRENT RATING CIRCUIT INFORMATION (What the fuse is fo 1 25 Amp Power outlet – Located top left column i 2 25 Amp Cigar lighter 3 10 Amp Left headlamp

When do you turn on the fan relay?

When the correct parameters are met, a temperature switch or the computer will activate the relay, which will allow power to the fans. The relay will usually be activated once it is detected that the vehicle’s temperature approaches excessively high temperatures.

When does the first relay turn on the fan?

1ST RELAY TURNS ON FAN WHEN TEMP SWITCH IS ACTIVATED 5 AMP FUSE SIGNAL CIRCUIT 12V SWITCHED (IGNITION OR FUSE PANEL) Power “ON” when key is in the “RUN” position. 86 87 30 85 Optional override switch turns on fan, by-passing temp sensor and A/C relay.

Where is the fuse on an electric fan?

OPTIONAL 2ND RELAY OVERRIDES TEMP SENSOR AND TURNS ON FAN WHEN A/C IS TURNED ON TEMP SENSOR SWITCH IN RADIATOR COOLANT OR OPTIONAL ADJUSTABLE FAN SWITCH WITH RADIATOR PROBE (GROUND SWITCHING, NON- VARIABLE SPEED ONLY) 5 AMP FUSE POWER SOURCE SHOULD BE BATTERY OR JUNCTION BLOCK NEAR BATTERY FAN

Do you need a relay kit for a cooling fan?

A relay kit, our part number CCFKRL, will include everything you need to properly wire up your electric cooling fans, with the exception of additional wiring needed to complete all of the circuits. The first part of the installation is to install the electric fan to your radiator, and remove the mechanical fan.

What does the cooling fan relay switches do?

The cooling fan relay is the relay that controls the engine’s cooling fans . When the correct parameters are met, a temperature switch or the computer will activate the relay, which will allow power to the fans. The relay will usually be activated once it is detected that the vehicle’s temperature approaches excessively high temperatures.

How do you test a radiator fan relay?

Open your hood and take some time to locate your fusebox, which is mounted in front of the passenger side of the firewall. Remove the top cover to expose your fusebox and relays, check your radiator fan relays and remove them. Inspect for any damage to the pins or the body of the relay, such as bubbling or melting.

Where is the coolant fan relay located in a Mercedes Benz?

The coolant sensor is just one of them. It also looks at A/C refrigerant pressure and the outdoor ambient air sensor as well. Both the ECU and the climate control modules can directly control the fan and it’s speed. The fan itself is intelligent and has it’s own module as well.

Where is the radiator fan relay on a Chevy Cruze?

CRUZE OVERHEATING FAN NOT WORKING In this video we will show you where the radiator fan relay is located on Chevrolet Cruze. It is also known as Cooling Fan Relay. If this relay is bad your radiator fan will not work and your car may overheat. We demonstrated where the radiator fan relay is located on a 2015 Chevrolet Cruze.

Where is the fan relay located?

Fan relay is located one of two places — inside the fuse box, or on the front radiator crossmember, down low, visible from underneath the vehicle, usually on driver’s side.

What is a fan motor relay?

The fan motor relay performs the action of a switch, sending 12-volt power to the cooling fan and initiating its operation. Once the engine temperature drops below the threshold programmed into the powertrain control module, the cooling fan turns off. In some makes and models,…

Why do I need to check my cooling fan relay?

The cooling fan relay essentially functions as the switch for the engine’s cooling fans; and is therefore an important electrical component of the vehicle’s cooling system. Finally, if you suspect that your cooling fan relay, may possibly be having issues, have it checked.

Where does the cooling fan in the engine go?

The cooling fan in the engine compartment should turn on to pull air through the radiator and A/C condenser. A main cooling fan for the radiator. A second fan for the condenser.

Where is the cooling fan relay ( or switch ) located?

Where is the cooling fan relay (or switch) located. I want to replace it in an attempt to get the fans to work again. Where is it located. The radiator cooling fans will not come and it causes overheating. It may be the fan relay or switch (whatever it is called).

When to replace the fan relay in a radiator?

3.4L V6 I replace the water pump, the thermostat (twice), the cooling senor (twice) replace all fan relays, but the fans will not come on till it reach 220-225. What else can I try? Is there another senor somewhere?

What happens when a cooling fan relay fails?

If the relay fails, it will be unable to supply power to the fans, and as a result they will not operate. This can lead to overheating, especially when the vehicle is at a stop, where there is no forward motion by the vehicle to pass air over the radiator. 3. Cooling fans stay on at all times

Where is the underhood fuse / relay box located?

Step 1: Locate underhood fuse/relay box. Visually identify the underhood fuse/relay box. The box is typically located on either the driver or passenger side of the engine compartment near the fender. Step 2: Remove the fuse/relay box cover. Remove the cover from the top of the underhood fuse/relay box.

How to repair a cooling fan in your car?

Cooling fan. How to repair a cooling fan in your car DIY with Scotty Kilmer. How to inspect and repair a cooling fan that’s not working. There’s many reasons why a cooling fan could stop working, such as a bad sensor, relay, fuse and more. DIY car repair with Scotty Kilmer, an auto mechanic for the last 42 years. 1.

Where is the fuse for cooling fans?

The fuse for the cooling fan is usually a 30amp marked “cooling fan” in the fuse box in the engine compartment. Do you know what the 25amp fuse that is blowing is for ?

What does the cooling fan relay do on a car?

A cooling fan relay is used on vehicles that have an electrical fan to cool the engine . The function of the cooling fan relay is to convert a low voltage signal from either the electronic control module (ECM) or a thermostatically controlled sensor.

Why are my cooling fans running at all times?

3. Cooling fans stay on at all times. If the cooling fans are staying on at all times, this is another (less common) symptom of a possible problem with the cooling fan relay. If the relay shorts internally, it may cause power to be permanently switched on, which will cause the fans to run at all times.

What’s the best way to remove a fan relay?

Gently pinch the relay with your fingers and wiggle back and forth, all while also pulling up on the relay. The relay should pull free with nominal effort. Tip: It’s not uncommon for the relay to build up dirt and debris over time and therefore become difficult to remove.

Where is the fuse on an electric fan relay?

The orange wire on the relay should see a 12 volt signal when the ignition switch is turned on. The other two wires on the relay are the meat and potatoes of the system, with the yellow wire connecting to the battery along with the supplied fuse mounted within 12 inches of the battery.

Navigation