Where is balancer located on Honda CB 350?
The massive shaped design of the H’ness CB 350 radiates true royalty and its evergreen style is a manifestation of Honda’s originality. H’ness CB 350 uses a weight that has been added on the main shaft located in the rear of cylinder to balance the position and mass with the balancer shaft located in the front of the cylinder to eliminate …
How do you test the Honda immobilizer system?
Firmly turn the steering wheel to the left or right as you turn the key. This is the normal key position when driving. Several of the indicators on the instrument panel come on as a test when you turn the ignition switch from the ACCESSORY (I) to the ON (II) position.
Where is the Check Engine Light code on a Honda?
You may also retrieve Honda check engine light codes using the Malfunction Indicator Lamp (MIL), by counting the flashes as follows: 1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on.
How do you set the ignition point gap on a tach?
In fact, the ignition point gap can be set by adjusting the dwell angle. Attach the red lead on your meter to the negative “-” terminal on the ignition coil. Attach the black lead on your meter to any good ground on the engine; that is, an unpainted metal part. Set the meter for the number of cylinders your engine has.
How to adjust the points on a CB350?
1. Loosened the breaker locking screws and set the clearance to 0.35mm, re-checked after tightening. 2. Hooked a test light up to a cooling fin, and held the tip to the spring on the left point. 3. Turned the crankshaft at the alternator counter-clockwise until the light turned on. 4. Did 2 and 3 for the right point.
How do you mark a cylinder number on a car?
Mark the spark plug wires for the cylinder number using a short piece of masking tape on each wire. Remove all the spark plugs using the spark plug wrench. The engine will be easier to turn by hand with the spark plugs removed and it’s a good time to replace them if required. Remove the valve cover from over the number one cylinder.
How do you set ignition timing with no timing marks?
Rotate the engine very slowly back and forth until the screwdriver is at the maximum height. This indicates the number one cylinder is at Top Dead Center or “TDC” on the compression stroke. Locate the number one spark plug wire on distributor cap and make a tic-mark of this position with a marker pen on the distributor housing.
How do I set the ignition on the number one cylinder?
Rotate the engine clockwise and observe the valves on the number one cylinder. When both valves are in the up position, insert a screwdriver into the number one cylinder through the spark plug hole.