Where does the emblem for trigger come from?
Trigger’s emblem is an homage to Air Combat 22, where the Aces squadron emblem features an animal holding a revolver in its mouth. A reflection of Trigger can be seen during the briefing for Transfer Orders. In the briefing, McKinsey dismisses the pilots, then calls Trigger back.
Who is the best person to fix a locked steering wheel?
With over 30 years of experience in the automotive industry, Hovig specializes in the process of auto repair and maintenance. He is also very knowledgeable in common automotive issues and needs including engine repair, battery replacement, and windshield accessory and maintenance.
Is the reluctor wheel on the rear of the crank?
Most aftermarket crankshaft manufacturers sell LS cranks with the wheel already installed, but it’s possible that you bought a crank where the reluctor wheel is sold separately. This isn’t a simple matter of hammering the wheel onto the rear of the crank.
What to do when your steering wheel wont turn?
If the ignition cylinder has seized, spraying a small amount of electrical cleaner into the key hole may lubricate it enough to turn. Be careful not to spray too much into the key hole. A few short squirts should suffice. Once done, insert the key and turn it back and forth gently to work the lubricant in.
Do you need to install a trigger wheel?
You will need to install the trigger wheel so the missing tooth is a specific number of degrees ahead of the VR sensor when the engine is at top dead center in order to use the settings in our articles.
What kind of trigger wheels do I need for Megasquirt?
DIYAutoTune.com presents our line of 36-1 trigger wheels for use with the Megasquirt. The trigger wheels are laser cut from 11 gauge (1/8″ steel) and work with Megasquirt-I with the MSnS-E code, and Megasquirt-II with either the standard or MS2/Extra code.
Can a crank pulley be mated to a trigger wheel?
If the crank pulley has extra material to machine the necessary 36-1 pattern, identical results can be obtained compared to the ‘traditional’ technique of mating special trigger wheels to crank pulleys.
How are the teeth of a trigger wheel made?
The technique used can be as elaborate as replicating the equivalent trigger wheel teeth pattern into the pulley, to simply milling/drilling a series of holes representing the pattern. Regardless of technique used, it’s critical the pattern is accurately machined into the pulley to ensure proper ignition timing.