Where do I find the error code on my Yamaha?
To clear the error from the system memory come on line d62 and includes buttons stop the engine on the right panel. When you enter the diagnostic mode, the display shows the cell [d01]. Press Select (top) need to go to the index [d60] (self-test in real time) and [d61] (memory error) and see the number next.
What is the diagnostic code for a Yamaha snowest?
All codes come from 08 Nytro shop manual. Also has diagnostic codes. Part #26 in the diagram is a wiring harness adapter for the 2011 updated relay. Yamaha part #8HG-81952-00-00
How to check Yamaha motorcycle fault code DTC?
Error codes DTC of Yamaha Motorcycle. Explanation and Troubleshooting. To enter the diagnostic mode and check the existing error codes in memory, do the following: 1. Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector.
What does a bad camshaft position sensor code mean?
Once your car’s computer detects a CMP sensor failure, it will trigger the engine light and store a diagnostic trouble code (DTC) in its memory (see the table below for common camshaft position sensor trouble diagnostic codes). IV. CMP Codes and What They Mean
What are the fault codes for a Yamaha R6?
15 – Throttle position sensor (for throttle valves): open or short circuit detected. Throttle position sensor (for throttle valves) coupler connection is loose. 17 – EXUP servo motor circuit: open or short circuit detected or loose connection. 18 – EXUP servo motor is stuck.
What do the error codes on a Yamaha motorcycle mean?
D: 60 = EEPROM, list of system errors (00 = no error, error code = 01-04 in the cylinders, if more than one memory errors, they are displayed alternately) D: 61 = list of errors on the ignition module sensors (00 = no errors in memory, 11-70 = error codes for the components if more than one memory errors, they are displayed alternately)
How to check a Yamaha er-3 fault code?
Er-3 – it is impossible to consider the testimony from the ignition module; Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds.
What is the diagnostic code for bad throttle position sensor?
Using a code reader, you should be able to confirm whether a faulty TPS is the culprit or a different component. Diagnostic trouble codes P0120, P0121, P0122, P0123, and P0124 are what will commonly appear. The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM.
How to turn off diagnostic mode on a Yamaha?
Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds. 4.
What is the fault code for a Yamaha motorcycle?
34 – faulty ignition coil cylinder 2 – self-diagnosed string D: 31; 35 – faulty ignition coil 3 cylinder – self diagnosed string D: 32; 36 – faulty ignition coil 4 cylinder – self diagnosed string D: 33;
Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds. 4.