Where can I buy a Hyundai Accent clutch set?
Shop AutoZone for Hyundai Accent Clutch Set. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only Sleek and economical, your Hyundai Accent is the perfect daily driver.
How to service a Hyundai pull type clutch?
Hyundai and Kia pull type clutches have a few unique service procedures. We’ll show you the trick to getting the transaxle unlocked from the clutch and how to setup the clutch and bearing for an easier assembly. For instruction bulletins and additional videos by our part number go to www.clutchtechsupport.com Loading…
What kind of shift cable does Hyundai use?
We offer a full selection of genuine Hyundai Accent Shift Cables, engineered specifically to restore factory performance. Please narrow the Transmission Shift Cable results by selecting the vehicle.
How to remove a clutch slave cylinder in a Hyundai?
They are kinda hard to see and the brake booster makes it a little more difficult. Disconnect the fluid line running from the master cylinder to the driver side motor mount and these two bolts. Take out the pin on the rod connecting the clutch pedal to the master cylinder and it should simply slide out.
How to remove a clutch from a master cylinder?
Disconnect the fluid line running from the master cylinder to the driver side motor mount and these two bolts. Take out the pin on the rod connecting the clutch pedal to the master cylinder and it should simply slide out.
How to make a clutch slave cylinder work?
Fill the master reservoir up and watch it slowly go down until it starts running out the bleed screw. Tighten the bleed screw, fill back up the reservoir and have someone pump the clutch a few times, hold it, and loosen and tighten the bleed screw to get any bubbles out. You have a beta swap, correct.
When do you need a new Hyundai Accent clutch kit?
When your friction disk wears down, that means it is time for a new Hyundai Accent clutch kit from AutoZone, and further inspection reveals other parts that also need to be cleaned or replaced. Use the form above to tell us what you drive. Clutch Kit. 8 1/2″ Clutch Diameter. 20 Tooth Spline. 7/8″ Input Shaft Diameter. For technical ass …
How do you replace a clutch master cylinder?
Step 1: Install entire system. Very carefully, install the entire system (clutch master cylinder, hydraulic line, and slave cylinder) down through the engine compartment. Warning: Do not bend the hydraulic line as it will break. Step 2: Install the slave cylinder.
Where is the clutch master and slave cylinder?
The cylinder is connected to the clutch master cylinder located on the firewall next to the brake master cylinder through a hose. When you push the clutch pedal, brake fluid flows from the clutch master cylinder to the slave cylinder, applying the pressure necessary to engage the clutch.
What causes a clutch slave cylinder to leak?
The main chamber seal in the middle of the clutch slave cylinder will split and leak out brake fluid causing the reservoir in the clutch master cylinder to become low. As the pedal is pushed down, the plunger inside the cylinder housing will cause brake fluid to spray out at a strong force past the seal.