Where are the wires on a Jeep Grand Cherokee?
Push the seat back, and place your tools on the floor of the car. There are a few wires hanging below the passenger side dash. The blower motor adapter is a bundle of three wires located on the left side. While the car is on push and pull gently on the wire connection. If the fan turns on you have identified the problem and we will fix it.
Why is my Jeep Grand Cherokee AC not working?
The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified.
How to remove AC adapter from Jeep Grand Cherokee?
There are two screws holding the adapter in place. Using a Phillips head screwdriver, remove both screws in order to remove and gain access to the adapter. The two screws are identical. Be careful not to lose them. Be sure the car is completely off before unscrewing anything.
Where is the blower motor adapter on a Jeep Grand Cherokee?
The blower motor adapter is a bundle of three wires located on the left side. While the vehicle’s ignition is on, push and pull gently on the wire connection. If the blower motor turns on, you have identified the problem and following this guide will help you fix it
What is the wiring diagram for a 1999 Jeep Grand Cherokee?
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 1999-2004 Jeep Grand Cherokee . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle.
The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified.
What is the repair manual for a 2007 Jeep Wrangler?
2007 Jeep Wrangler JK / Jeep Liberty KJ / Jeep Compass MK / Jeep Grand Cherokee WK / Jeep Commander XK SERVICE & REPAIR MANUAL – DOWNLOAD! Download Now
What is the repair manual for a 2003 Jeep Liberty KJ?
2003 JEEP LIBERTY KJ FACTORY SERVICE / DIY REPAIR MANUAL (Free Preview, Complete FSM Contains Everything You Will Need To Repair Maintain Your Vehicle!) Download Now
How to fix AC and heater in 1999 Jeep Grand Cherokee?
Clarify it by editing! The 1999-2004 Jeep Grand Cherokee has a common failure where the blower fan wire adapter overheats and melts. Use this guide to fix and repair this connector and get your AC and Heater working again! No parts specified. Place the car in park, activate the parking brake, and leave the car running.
Where is the fuse panel on a Jeep Grand Cherokee?
If the fuse blows again, have the vehicle inspected at a qualified service center. The interior fuse panel is on the lower instrument panel just to the left of the steering column. A label is stamped on the fuse panel cover to identify each fuse for ease of replacement.
How many volts does a Jeep Grand Cherokee have?
PART COLOR LOCATION 12 VOLT CONSTANT PINK/BLACK (+) and RED (+) IGNITION SWITCH HARNESS STARTER YELLOW (+) IGNITION SWITCH HARNESS STARTER 2 N/A IGNITION 1 DARK BLUE (+) IGNITION SWITCH HARNESS
What should I use to unlock my Jeep Grand Cherokee?
NOTE *1 Use ORANGE/VIOLET for LOCK and PINK/BLACK for UNLOCK at the DRIVERS DOOR SWITCH. Use BLACK/WHITE for LOCK and PINK/BLACK for UNLOCK at the passenger front door switch. This vehicle requires (2) of part # 778 one for each door See DIAGRAM.
Where is the BCM located on a Jeep Grand Cherokee?
On the 4.0L engine, use any wire with a TAN STRIPE at the coil pack NOTE *5 to DISARM the FACTORY ALARM SYSTREM requires a (-) NEGATIVE thru a 463 Ohm Resistor and an extra relay part #775, to connect, See DIAGRAM NOTE***** the BCM (Body Control Module) is located above the DIAGNOSTIC PLUG under the dash.