Where are the low beams on a Hyundai Sonata?

Where are the low beams on a Hyundai Sonata?

The Hyundai Sonata has a composite headlight assembly. One bulb is for high beams and the other is for low beams. The low beams are located below the high beams in the headlight assembly. Fortunately, there are no special tools needed to replace this bulb and the entire job shouldn’t take you more than a few minutes.

What kind of light bulb does a Hyundai Sonata use?

Disconnect the power cord from the bulb base at the back of the assembly. Push the bulb spring on the assembly to remove the light bulb. Pull the old bulb out and place the new bulb in. The low-beam lights use H7 bulbs. The high-beam lights use H1 bulbs.

What to do if your Hyundai Sonata headlamp is not working?

Turn off the engine. Allow it to cool down before checking the connections. Open the hood. Lightly tug on the electrical connector at the rear of Sonata’s headlamp assembly. If the connector comes out, securely plug it into the rear of the assembly. If the headlights are still malfunctioning, you may need to replace the bulb.

Is it possible to fix a bad low beam headlight?

Fortunately, fixing a bad low beam is a straight forward process in the majority of vehicles that can be done by most people without just a few hand tools. If replacing your headlight bulb does not work, there may be an electrical issue in your vehicle that should be addressed by a professional. Identify a blown out bulb.

Disconnect the power cord from the bulb base at the back of the assembly. Push the bulb spring on the assembly to remove the light bulb. Pull the old bulb out and place the new bulb in. The low-beam lights use H7 bulbs. The high-beam lights use H1 bulbs.

Why does my Hyundai Sonata go from low to high beams?

It’s obviously a bad connection within the blinker stalk, causing the light mode to change on its own when turning. Headlights flicker and/or switch from low to high beams when using turn signal. The turn signal stalk contains the on/off/auto switch for the headlights as well as the high/low beam selection.

What’s the problem with the headlight switch on a Hyundai Sonata?

Headlight Switch problem of the 2014 Hyundai Sonata 1 Failure Date: 10/18/2020 The headlamp switch appears to have a malfunction. Touching it to turn on the blinker or the bright lights can cause the headlights and dashboard lights to flicker.

Are there any recalls on the Hyundai Sonata?

2011 Hyundai Sonata defect in the light stem switch that causes headlights and dash lights to flicker the consumer stated he began to experience occasional episodes of flickering headlights, especially when switching between high and low beam. Takata recall – in September 2014 my battery were going dead.

What to do if your Hyundai Sonata has a bad headlight?

If the headlights on your Hyundai Sonata are malfunctioning, they should be fixed immediately. Faulty headlights can obscure road vision and lead to car accidents and serious injury. Loose electrical connections, burned out bulbs and popped fuses create most headlight problems, and all three have a quick fix. Turn off the engine.

Do you need to replace both high and low beams?

Some vehicles use a single bulb for both high and low beams while others do not. If the high beam on the same side is also out, it may be one bulb. You do not need to purchase specific bulbs for each side, but identifying which is the blown out bulb will help you to replace it without having to start the vehicle again.

What’s the problem with a low beam headlight?

Driver’s side low headlight out. Checked connector, both sides, from negative battery terminal to connector. One side 0 voltage, assume it is negative side. One side 3.5 volts, assume it is positive side. Believe this means fuse is OK but voltage not adequate, need 12 volts. Solution? I am having the EXACT same problem. Bulb is good.

If the headlights on your Hyundai Sonata are malfunctioning, they should be fixed immediately. Faulty headlights can obscure road vision and lead to car accidents and serious injury. Loose electrical connections, burned out bulbs and popped fuses create most headlight problems, and all three have a quick fix. Turn off the engine.

Can a low beam light stop working at the same time?

[Archive] – Teton Gravity Research Forums View Full Version : Both Low Beam Headlights Dead At the Same Time? Both my low beam headlights stopped working at the same time this evening. High beams are still fine. I’ve never seen two headlights go out at the same time.

Where is the headlamp fuse on a Hyundai Sonata?

Locate the under-hood junction box on the driver’s side of the vehicle, behind the engine. Remove the cover and locate the fuse labeled “HD LP LO.” This is the headlamp fuse.

The Hyundai Sonata has a composite headlight assembly. One bulb is for high beams and the other is for low beams. The low beams are located below the high beams in the headlight assembly. Fortunately, there are no special tools needed to replace this bulb and the entire job shouldn’t take you more than a few minutes.

Turn off the engine. Allow it to cool down before checking the connections. Open the hood. Lightly tug on the electrical connector at the rear of Sonata’s headlamp assembly. If the connector comes out, securely plug it into the rear of the assembly. If the headlights are still malfunctioning, you may need to replace the bulb.

Locate the under-hood junction box on the driver’s side of the vehicle, behind the engine. Remove the cover and locate the fuse labeled “HD LP LO.” This is the headlamp fuse.

Posted In Q&A