Where are the circuits on a Mercury Mariner?
Cut the three circuits on the female side of the connector (14334 harness). 7. Identify circuits CBP05 (YE) and GD143 (BK-VT) from C248. 8.
How to replace the starter on a 2004-2008 Ford Explorer?
In this video I show how to replace a starter on a 2004 to 2008 Mercury Mountaineer or Ford Explorer with the v6 engine. You will need a 13mm deep socket, a 13mm shallow socket, a 10mm wrench and an 8mm wrench (for battery cable). Your starter will be located on the same side as the battery. Loading…
How to connect a mic to a Mercury Mariner?
Connect the microphone connector to the jumper harness connector. 10. Bundle and tuck the remainder of the microphone cable above the headliner. 2008-2009 Explorer / Explorer Sport Trac / Mountaineer 1. Remove the protective backing from the adhesive on the microphone and attach the microphone.
What should I remove from my Mercury Mariner?
Remove the rear seat lower cushion. Taurus X 7. Release the 2 load floor support brackets and position the load floor upward. 8. Remove the 4 load floor support-to-floor pan nuts. – To install, tighten to 18 Nm (13 lb-ft). 9. Remove the 2 load floor support brackets. All vehicles 10. Remove the fuel level sensor access cover.
Are there any recalls on the 2008 Mercury Mariner?
The 2008 Mercury Mariner has been recalled 4 times by NHTSA. View Recalls Reliability indicates how models have performed in the past, providing the basis for predicting how the vehicles will hold up in the year ahead. These charts provide the most comprehensive reliability information available to consumers.
How is the interior of a Mercury Mariner?
The interior is roomy and the rear bench seat is spacious. The 3.0-liter V6 provided adequate acceleration in our test of the Escape and returned 19 mpg. Noise and ride comfort are good. However the Escape’s lack of tire grip negatively affects handling and braking.
What kind of reliability does a Mercury Mariner have?
The Reliability score is based on our latest subscriber survey of 2008 Mercury Mariner owners. The owner comments describe problems respondents experienced with this vehicle. Paint (fading, chalking, cracking, or peeling), loose interior and exterior trim or moldings, rust.
Remove the rear seat lower cushion. Taurus X 7. Release the 2 load floor support brackets and position the load floor upward. 8. Remove the 4 load floor support-to-floor pan nuts. – To install, tighten to 18 Nm (13 lb-ft). 9. Remove the 2 load floor support brackets. All vehicles 10. Remove the fuel level sensor access cover.