When to use DTC p1582 in a Jaguar?
It is accepted that DTC P1582 will be present with a throttle/inertia switch failure. However, it is there to notify that the ECM data recorder has recorded data. Under these circumstances there will be associated DTCs present for the failure that occurred. Note: DTC P1582 cannot be cleared in the normal way using DTC monitor on WDS.
What is the diagnostic code for a Jaguar check engine light?
Refer to our Generic OBD II code list for definitions on all other Jaguar diagnostic trouble codes. Manufacturer Specific Codes P1000OBD Systems Readiness Test Not Complete P1104Mass Air Flow Sensor Circuit Ground – Read Our Article On Automotive Circuit TestingFor Help With This Jaguar Check Engine Light Code P1111System Pass
What does DTC p1582 mean in a stall?
Engine stall. If DTC P1582 is the only code present, it does not necessarily mean that a failure has occurred – it is more likely to be the result of a hesitation/stall event as detailed in conditions 3, 4 and 5 above. It is accepted that DTC P1582 will be present with a throttle/inertia switch failure.
What happens to the DTC p1582 flight recorder?
To clarify any confusion there may be with DTC P1582 (Flight recorder), the following information applies: DTC P1582 (Flight recorder) data is stored if any one of the five conditions listed below occur: 1. Inertia switch activated. 2. Throttle failure causes default into limp home mode. 3. Engine starts and stumbles. 4. Engine fails to start. 5.
It is accepted that DTC P1582 will be present with a throttle/inertia switch failure. However, it is there to notify that the ECM data recorder has recorded data. Under these circumstances there will be associated DTCs present for the failure that occurred. Note: DTC P1582 cannot be cleared in the normal way using DTC monitor on WDS.
What should intake manifold pressure be on a Jaguar?
Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v. Both The car runs great but will not pass smog test…. The catalytic converter will not reset to be ready for a smog test.
Refer to our Generic OBD II code list for definitions on all other Jaguar diagnostic trouble codes. Manufacturer Specific Codes P1000OBD Systems Readiness Test Not Complete P1104Mass Air Flow Sensor Circuit Ground – Read Our Article On Automotive Circuit TestingFor Help With This Jaguar Check Engine Light Code P1111System Pass
Engine stall. If DTC P1582 is the only code present, it does not necessarily mean that a failure has occurred – it is more likely to be the result of a hesitation/stall event as detailed in conditions 3, 4 and 5 above. It is accepted that DTC P1582 will be present with a throttle/inertia switch failure.
Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v. Both The car runs great but will not pass smog test…. The catalytic converter will not reset to be ready for a smog test.
Is the JAG 2.5 V6 actually a Ford V6?
If the engine is not able to be fixed economically, could the ford mondeo 2.5 v6 24v fit straight into its place – i believe the Jag V6 is actually a Ford V6?? Any help would be greatly appreciated. Hi Benn and welcome to the forum, it’s just a pity you are starting with a problem.
Why is my Jaguar 2.5 engine making a tapping noise?
After being run a little low on oil, the engine started to make a small tapping noise – Jaguar refilled with oil and said it may be a bottom end fault but the oil should help – it didnt – on the way back from a long trip – the engine started to make a horrendous knocking sound when revving, and oil began leaking.
What is the OBD2 code for a Jaguar XJ?
OBDII Jaguar Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.