When to ignore BMW diagnostic code 1219 Group 2?

When to ignore BMW diagnostic code 1219 Group 2?

If code recurs and no other defects are found the DME is most likely damaged and must be replaced. If the code does not recur and the engine runs properly, ignore. 1219 Output Stage, Group 2 This code is stored if there is a short to B+ or Ground at the Output Amplifier Stage (Bank 2). Generally this code occurs with other defects.

When to use 1213 lambda control 2 code?

Note: Cars without Catalytic Convertors will incorrectly store this code. 1213 Lambda Control 2 This code is stored when the DME detects excessive deviations in the air-fuel mixture (too rich or too lean) for longer than 10 seconds.

When do I delete the Diagnostic Code 1211?

CODE MALFUNCTIONING SYSTEM EXPLANATION 1211 DME Control Unit This code is stored when the DME self test fails. Delete any stored codes. Start and run the car for 30 seconds. Turn off the ignition for 30 seconds. Rerun the diagnosis.

What is the code for the Check Engine light?

P1212Injector Control Pressure Not Detected During Crank P1213Start Injector Circuit Malfunction P1214Pedal Position Sensor B Circuit Intermittent P1215Pedal Position Sensor C Circuit Low Input P1216Pedal Position Sensor C Circuit High Input P1217Pedal Position Sensor C Circuit Intermittent P1218CID High P1219CID Low

What is the code for left front wheel speed sensor?

Code C0035 may be set when the car’s anti-lock brake module perceives a fault with the left front wheel speed sensor or its circuit. Wheel speed sensors are installed in your car to determine how fast each wheel is turning.

What to do if you get a c1233 code?

Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the C1233 code is 1.0 hour of labor.

What does c1233 mean on an ABS module?

C1233 Meaning. The ABS module receives wheel speed readings from each wheel speed sensor and processes this information to determine if an ABS event is necessary.

Posted In Q&A