When to disconnect the IoD fuse on a jeep?
A 2008 TSB instructed Jeep owners to do an IOD fuse disconnect for 10 seconds. If this step failed, the technician was to replace the WCM. These vehicles may show symptoms similar to a blown IOD fuse, so it is best to eliminate all other possible reasons before concluding that the IOD is the cause.
Where is the ignition off fuse located on a car?
The Ignition-Off Draw (IOD) fuse is located in the Total Integrated Power Module (TIPM), usually found near the battery in the engine compartment. Depending on your vehicle model, it may elsewhere, such as below the steering wheel or dashboard.
Where is the IoD fuse located in a car?
The IOD fuse is located in the vehicle’s engine compartment. It could be on either side of the dashboard or instrument panel, under the hood, or below the steering wheel. Refer to your vehicle’s fuse box diagram or this guide when locating or replacing the IOD fuse. Adventure seeker and off-road enthusiast.
When does the battery drain in a jeep?
For Jeeps, the battery drain happens when the security system goes through a panic attack, or if the (WCM) metal key blade gets static electricity buildup and fails to read the transponder. A 2008 TSB instructed Jeep owners to do an IOD fuse disconnect for 10 seconds.
A 2008 TSB instructed Jeep owners to do an IOD fuse disconnect for 10 seconds. If this step failed, the technician was to replace the WCM. These vehicles may show symptoms similar to a blown IOD fuse, so it is best to eliminate all other possible reasons before concluding that the IOD is the cause.
How can I tell if my IoD fuse is faulty?
Take one end of the multimeter, put it on the negative post, and then put the other on the negative cable terminal. Then pull the fuses one by one. Pulling the faulty fuse would give a reading of 0 amp or show a sudden drop in amperage reading.
What is controlled by the IoD fuse on a Chrysler minivan?
If the vehicle is equipped with an illumi- to automatically shut off (time out). This may take up to twenty minutes. (2) Disconnect the battery negative cable. highest amperage scale. Connect the multi-meter minal clamp and the battery negative terminal post. illuminated entry system is not activated.
For Jeeps, the battery drain happens when the security system goes through a panic attack, or if the (WCM) metal key blade gets static electricity buildup and fails to read the transponder. A 2008 TSB instructed Jeep owners to do an IOD fuse disconnect for 10 seconds.