When does auto start stop dissconnected check engine warning messag?
Auto start stop dissconnected check engine warning messag… When my car is in neutral (even when the auto start stop function isnt turned on) i see the error message auto start stop unavailable check engine. Then i see the engine warning light on the dashboard.
How long does the SRS warning light stay on?
While your car will run with this light on, it is important that you diagnose this problem as soon as possible. Under normal operations, when you first turn the ignition and start the car the light stays on for about 5 seconds and then turns off.
How does the SRS warning system work in a car?
SRS Warning System. The SRS system checks the operation of several components in your car such as: Airbags. Airbag control unit. Crash sensors. Emergency Tensioning Devices. Belt force limiters. Child occupancy sensor in front passenger seat.
How to avoid ” last message repeated ” in NX OS?
I use the _CONFIG_I message to trigger config check-in into config repository and this feature effectively hides it. Solved! Go to Solution. 09-03-2015 06:32 AM 09-03-2015 06:32 AM CSCts88978 added the CLI to disable the logging rate-limit.
Auto start stop dissconnected check engine warning messag… When my car is in neutral (even when the auto start stop function isnt turned on) i see the error message auto start stop unavailable check engine. Then i see the engine warning light on the dashboard.
Why does rear side cross alerts not work?
The rear side cross alerts don’t work. The whole dash went blinked on and off black, the XM radio doesn’t work (called XM and the subscription is still good and they resent the signal to no avail), I get intermittent brief blinking of the dash with “service air bag” warnings.
Why do I get an error message when I start my car?
Software detects this, and shuts off the feature; hence the error message. Ford may offer a warranty repair, or technical service bulletin for this problem – although this has not been reported as of this response.
What to do if your service side detection system has been replaced?
Take it to another dealership and explain what has been replaced already. Sounds like there might be a bad sensor or wire pinched somewhere. The module is likely the easiest part to replace, so the dealership just tries that first instead of troubleshooting properly. will this help?