When do I need to re-synchronize my Mercedes Benz sunroof?

When do I need to re-synchronize my Mercedes Benz sunroof?

Re-synchronization of your Mercedes-Benz windows and sunroof may be required if your sunroof and windows don’t work properly. This is a simple procedure that needs to be performed after you disconnect or replace the battery. Or if your battery died or is not holding a proper charge.

Why does my Mercedes sunroof not close properly?

Mercedes windows or sunroof does not close properly. MB window closes then drops an inch or a few centimeters. The express up or down (one-touch) feature does not work. Either the windows or the sunroof seems to require several clicks when closing or opening. How do you re-synchronize Mercedes windows? Close all the doors of your car.

What to do if Windows dont sync with sunroof?

Alternative steps if re-synch procedure doesn’t work. With the key in position 1 or 2, push the window button until it is completely open. Hold the button for 5 seconds. Pull it up to close and hold again for another 5 seconds. Check to see if the problem is fixed. Repeat steps 2 and 3 as needed.

What should I do if I Reset my sunroof?

If you hold it int he slide open, slide closed, or tilt up position, it can reset incorrectly. If you do incorrectly reset a window or the sunroof, the easiest solution is to pull the appropriate fuse to erase its memory, then reset it again. Doors closed bonnet/hood and boot/trunk closed and engine running. Click to expand…

Why is my Mercedes Benz sunroof not working?

If the sunroof in your Mercedes-Benz E-Class isn’t working, the cause might be easier to fix than you think. Follow these instructions to get your sunroof working again. This article applies to the Mercedes-Benz E-Class and E-Class AMG w211 (2002-2009).

How to synchronize Mercedes Benz windows and sunroof?

Once you reach the fully open position, continue to HOLD the sunroof switch in the OPEN position until hear a click. If you don’t hear the click make sure to hold the switch for up to 5 seconds. Next, close the sunroof and again hold the switch for 5 seconds when you reach the closed position Check if the problem has been fixed.

How much does it cost to replace the sunroof on a Mercedes Benz?

A replacement sunroof motor costs between $40 and $250. Follow these steps to install the new one. Disconnect the negative lead (black) of the battery terminal. Manually slide the sunroof approximately two-thirds of the way open. With a trim removal tool, unfasten the expansion snaps and pull the interior headliner panel out.

What kind of lubricant do you use on a Mercedes-Benz sunroof?

Apply lubricant along the sunroof track. Check the dealership for genuine Mercedes-Benz sunroof lubricant, which costs around $10. If unable to find it, it is recommended using aftermarket lubricants such as lithium grease, synthetic grease, or liquid Teflon.

How does auto close work on a Mercedes Benz?

Older Mercedes-Benz models before 1995 will most likely not have the auto close feature. They may have a micro switch on the window regulator that the window toggles on and off when it reaches the top or bottom position. When I park or turn off the car and try to close the windows, they do not go up all the way.

How do you reset the sunroof on a Mercedes?

If the car has been turned off while the sunroof is closing, it may need to be properly reset. Press the button that closes the sunroof, and hold it for five seconds. Press the button that opens the sunroof, and hold it for five seconds.

Are there any problems with the Mercedes sunroof?

Mercedes sunroofs are designed to add function and features to the Mercedes. It also enhances the look of the car and can be easily operated through controls on the dashboard. However problems can appear when it fails to close, is jammed, or leaks causing internal damage within the car.

Where are the retaining tabs on a Mercedes sunroof?

It is towards the rear edge of the overhead control panel, Approximately 2 inches from the left and on the right side is where the retaining tabs are present. The metal retaining tabs can be depressed forward using a small slotted screwdriver or any other similar thin tool.

Posted In Q&A