When did the Nissan 720 4 wheel drive come out?
Introduction The Datsun/Nissan 720 pickup was Nissan’s first foray into the 4 wheel drive mini-pickup market. It was introduced as a 1980 model and continued until 1986 when the current Hardbody style (model D-21) was introduced as a 1986.5 model.
When did the Datsun 720 first come out?
The Datsun/Nissan 720 pickup was Nissan’s first foray into the 4 wheel drive mini-pickup market. It was introduced as a 1980 model and continued until 1986 when the current Hardbody style (model D-21) was introduced as a 1986.5 model.
Where is the load sensing valve on a Nissan 720?
A load sensing valve is mounted to the frame ahead of the rear axle to modulate the brake pressure to the rear brakes. This valve is not serviceable. When bleeding the brake system, be sure to bleed the load sensing valve first.
What kind of front differential does the Nissan 720 use?
All 720s use a R180 front differential (180mm). Both automatic and manual locking hubs were offered from the factory on the 720. The auto locking hubs are of the variety that you must stop the truck to engage the hubs and back up 3 meters to disengage.
What kind of suspension does the Nissan 720 have?
The 720 features an independent front suspension with torsion bar springs, a leaf spring live axle rear suspension and a 4 cylinder engine displacing 2.0 litres at introduction later enlarged to 2.4 litres. Longbed and extra-cab models were also available.
Where is the transfer case on a Nissan 720?
The transmission on the 720 drives a divorced transfer case (that is, transfer case is separate from transmission). Later model Hardbodies and Pathfinders have a transfer case that is “married” (attached) to the transmission. The transmission shaft enters the transfer case at the top while front and rear driveshafts exit from the bottom.
Introduction The Datsun/Nissan 720 pickup was Nissan’s first foray into the 4 wheel drive mini-pickup market. It was introduced as a 1980 model and continued until 1986 when the current Hardbody style (model D-21) was introduced as a 1986.5 model.
Are there any modifications to a Nissan 720?
Modifications that are 50 state legal include replacing the exhaust system aft of the catalytic converter and a K+N air filter. Apparently, the head pipe between the manifold and the cat is 2″ diameter while the system aft of the cat is 1 3/4″. Going to a 2″ cat-back system will help reduce backpressure.
The Datsun/Nissan 720 pickup was Nissan’s first foray into the 4 wheel drive mini-pickup market. It was introduced as a 1980 model and continued until 1986 when the current Hardbody style (model D-21) was introduced as a 1986.5 model.
The transmission on the 720 drives a divorced transfer case (that is, transfer case is separate from transmission). Later model Hardbodies and Pathfinders have a transfer case that is “married” (attached) to the transmission. The transmission shaft enters the transfer case at the top while front and rear driveshafts exit from the bottom.
Modifications that are 50 state legal include replacing the exhaust system aft of the catalytic converter and a K+N air filter. Apparently, the head pipe between the manifold and the cat is 2″ diameter while the system aft of the cat is 1 3/4″. Going to a 2″ cat-back system will help reduce backpressure.
Is the fuel pump on my Nissan 1400 1985 working?
Clide Tshuma on October 16, 2019: I’m sitting here with my nissan 1400 1985 model is not pumping fuel to curburater but when you fill 2 litter bottle with petrol it drives well I need your help Dwayne Oxford on February 28, 2019:
Why does my Datsun pickup truck not idle?
If any of these tests fail then the truck will not idle because they actually control the idle stop solenoid. To check the idle stop solenoid you should turn the key on and check for power at the red wire for the solenoid. Or if powered directly from the battery you should hear it clicking.
What was the problem with my Nissan 85?
I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector. Still engine did not want to idle it would run erratically and died. Then I proceeded to check the electrical circuit.
Clide Tshuma on October 16, 2019: I’m sitting here with my nissan 1400 1985 model is not pumping fuel to curburater but when you fill 2 litter bottle with petrol it drives well I need your help Dwayne Oxford on February 28, 2019:
If any of these tests fail then the truck will not idle because they actually control the idle stop solenoid. To check the idle stop solenoid you should turn the key on and check for power at the red wire for the solenoid. Or if powered directly from the battery you should hear it clicking.
I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector. Still engine did not want to idle it would run erratically and died. Then I proceeded to check the electrical circuit.
The 720 features an independent front suspension with torsion bar springs, a leaf spring live axle rear suspension and a 4 cylinder engine displacing 2.0 litres at introduction later enlarged to 2.4 litres. Longbed and extra-cab models were also available.
All 720s use a R180 front differential (180mm). Both automatic and manual locking hubs were offered from the factory on the 720. The auto locking hubs are of the variety that you must stop the truck to engage the hubs and back up 3 meters to disengage.
What kind of fuel pump does a Nissan 720 have?
Dan has been an auto mechanic, truck driver, engineer, and many other things. This article is for owners of the 1981–1985 Datsun or Nissan 720 pickups with the electric fuel pump. On this page, you will learn how to go beyond the typical service manual fuel delivery problem diagnosis.
Are there any problems with the Nissan 720?
Dwayne Oxford on February 28, 2019: See no way to reply to questions/posts here, but those of you having probs with Nissan 720’s need to be at 720 World. Tim on February 04, 2019: bcstoy – carburation part II on January 22, 2019: I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector.
What kind of tires do you put on a Nissan 720?
The later Z24 engines use a a 240mm clutch. The 720 came stock with 215/75R15 size tires which are 28″ in diameter. 30×9.5-15 size tires will fit at stock height with no rubbing while 31×10.5-15’s will fit with some rubbing. I wouldn’t recommend tires larger than 31″ without swapping in lower gear ratios anyways.
How much does a Nissan 720 part cost?
THIS ITEM IS 100% UNIQUE OEM FROM NISSAN, BRAND NEW. THIS ITEM IS 100% UNIQUE OEM FROM NISSAN, BRAND NEW. THIS ITEM IS 100% UNIQUE OEM FROM NISSAN, BRAND NEW. THIS ITEM IS 100% UNIQUE OEM FROM NISSAN, BRAND NEW. THIS ITEM IS BRAND NEW AFTERMARKET PART. PART # 72019 $ 49.00 US $. EACH THIS ITEM IS 100% UNIQUE OEM FROM NISSAN, BRAND NEW.
What kind of transmission does the Nissan 720 have?
Description The transmission on the 720 drives a divorced transfer case (that is, transfer case is separate from transmission). Later model Hardbodies and Pathfinders have a transfer case that is “married” (attached) to the transmission.
How to speak to a Nissan Drive train expert?
To speak to a Drive Train Expert or to place and order call toll free 888-824-2012! Having issues diagnosing problems with your FS5W71 Nissan 5 Speed manual transmission we can help. We have a large inventory of rebuilt FS5W71 Manual Transmissions plus transmission parts.
The later Z24 engines use a a 240mm clutch. The 720 came stock with 215/75R15 size tires which are 28″ in diameter. 30×9.5-15 size tires will fit at stock height with no rubbing while 31×10.5-15’s will fit with some rubbing. I wouldn’t recommend tires larger than 31″ without swapping in lower gear ratios anyways.