When did the Mercury Grand Marquis recall start?
(TRW) MANUFACTURED FROM JUNE 1, 1998 THROUGH MAY 21, 2000. SOME OF THESE SEAT BELT ASSEMBLIES MAY HAVE BEEN INSTALLED AS SERVICE REPLACEMENT EQUIPMENT ON THE VEHICLES INVOLVED IN THE RECALL.
What happens when the headlamps go out on a Mercury Grand Marquis?
THESE VEHICLES WERE BUILT WITH THE NON-CYCLING POWER WINDOW CIRCUIT BREAKER AND THE CYCLING HEADLAMP CIRCUIT BREAKER INTERCHANGED. IN THE EVENT OF A SHORT OR OVERLOAD IN THE HEADLAMPCIRCUIT, BOTH HEADLAMPS CAN GO OUT WITHOUT WARNING, RATHER THAN FLASHING AS INTENDED WITH THE CYCLING CIRCUIT BREAKER.
Can a Mercury Grand Marquis steering shaft separate?
These aftermarket replacement steering shafts are sold for use in 1995-2002 Ford Crown Victoria, Mercury Grand Marquis, and Lincoln Town Car vehicles. These steering shafts may separate during operation if the integral fastener is loose or missing and if the interfacing vehicle shaft is compressed in length.
Is there a recall on the Mercury Grand Marquis?
Ford tends to use Plastic when they should not. The Ford company needs to recall the intake manifold because of this faulty part. Cost of replacement of coils and intake manifold over $1,300. Now car is bucking again and other coils may need replacing because of this slow leak.
What to do if your Mercury Grand Marquis has a water leak?
Put something like a block of wood on the end of the hose so that it stays there. turn on the water so it rolls towards the front and down the windshield…and over the front and hopefully rear door. Let the water run. Be patient. Get out your flashlight and open the pass front door so you can observe any water trailscoming in on the drivers side.
Is the Mercury Grand Marquis still in production?
The Mercury Grand Marquis is a sedan that was manufactured by Ford from 1975-2011. The model has been discontinued. Read more Ford reviews to learn about other models. Time for a new car and not sure where to start?
Is the intake manifold on the Mercury Grand Marquis faulty?
2005 Mercury Grand Marquis Intake Manifold part is faulty due to substandard plastic piece. Caused a crack and it leaked engine coolant and then caused engine to overheat. Coils and plugs needed replacing. Ford tends to use Plastic when they should not. The Ford company needs to recall the intake manifold because of this faulty part.
Is there a recall on Ford Crown Victoria?
Ford Motor Company (Ford) is recalling certain model year 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles manufactured October 3, 2001, to August 2, 2005. The affected vehicles have a lighting control module (LCM) that may fail, resulting in a loss of headlights.
What causes a Mercury Grand Marquis to overheat?
Caused a crack and it leaked engine coolant and then caused engine to overheat. Coils and plugs needed replacing. Ford tends to use Plastic when they should not. The Ford company needs to recall the intake manifold because of this faulty part. Cost of replacement of coils and intake manifold over $1,300.