When did the Honda Accord brake pads need to be replaced?
The rear brake pads have had to be replaced twice since i purchased this vehicle new, on october 7, 2009: the first replacement was on september 2, 2011 at 36,365 miles and the second replacement was on march 12, 2013 at 67,699 miles. 3. March 12, 2013 pad replacement. The inboard pads on both sides are worn down far more than the outboard pads.
How can I tell if my Honda Accord has a brake problem?
Honda’s corrective action was to replace the brake pads and refinish the rotors. Also, Honda tightened up the specs for runout and thickness variation during this time. Runout: For the front or rear rotors, set up the dial gauge against the rotor, and measure the runout at 10 mm from the outer edge of the disc.
How do you turn off the brake lights on a Honda Accord?
Use a flat head screwdriver to push against the switch. Then with the circular, flat end of the pedal stopper pad facing the switch, snap it into place. Release the brake light switch.
How often should you replace brake fluid in a Honda Accord?
Honda recommends replacing brake fluid every 45,000 miles or every 6 months. Brake fluid plays an important role in your car’s braking system because it lubricates moving parts to prevent corrosion, and it also transfers the force from a depressed brake pedal to the wheel hub in order to slow down the car.
Is there a problem with my Honda Accord rear brake?
Premature rear brake wear is a common problem on 2008-2010 Honda Accords. There are over 1,000 reports of premature brake wear for the 2008 Accord alone on carcomplaints.com. Keep in mind that only includes people who took the time to note their complaint
What does EBD do on a Honda Accord?
For 2008 Accords, Honda introduced a new braking system called the Electronic Brake Distribution system or EBD. EBD pushes the rear brakes harder than other braking syste ms to prevent nose dive. Consequently, the early EBD systems were found to have a design flaw that caused them to wear out brake pads too quickly.
How do you replace a brake caliper on a Honda Accord?
Put the round pin into the top of the caliper. Replace your worn brake pads with new ones. Reinstall the caliper onto its bracket. Reinstall the wheel onto the hub. Lower the wheel to the ground. Tighten the lug nuts to 80 foot-pounds. Repeat on the other rear wheel.