What would cause a Jeep to spit and sputter?
A dirty or failing sensor puts too much or too little fuel into the engine causing it to run rough or sputter. If they are not working correctly or are dirty they don’t ignite the fuel cleanly and the car can misfire or sputter. The plugs will need to be replaced or cleaned.
Is the Jeep Grand Cherokee 4.0 with no start?
Come along with Eric O. at SMA as he has a look at this 2001 Jeep Grand Cherokee with the I6 4.0 that was towed in with a crank, no start condition. It didn’t take long to figure out this common problem and solve the infamous P0320 crank sensor code.
How to troubleshoot a Jeep no start condition?
No Start Condition Basics. NO START 1: Checking For Spark. NO START 2: Checking For Fuel. NO START 3: Checking Engine Mechanical Condition. Cranks But Does Not Start Summary. More 4.0L Jeep Diagnostic Tutorials.
Why does my Jeep 4.0L have no spark?
It’s almost impossible for all 6 COP ignition coils to fail at the exact same time… so the most likely cause for this no spark condition is a bad crankshaft position sensor. But before you go out and replace the crank sensor, you need to test it (to make sure it’s fried).
Can a spark test be done on a no start Jeep?
Testing for spark can very easily and safely be done with a dedicated spark tester. If the ignition system is the cause of the cranks but does not start condition, you’re not gonna’ see spark at any of the 6 spark plug wires or 6 COP ignition coils.
What causes no start on a jeep 4.0L?
Updated: 29 June 2019. Article Id: 420. A no start condition, on your 4.0L Jeep, is usually caused by a lack of fuel, or a lack of spark, or a lack of air (generally engine compression).
Why does my Jeep turn over but does not start?
Cranks But Does Not Start Condition: In this type of condition, you turn the key and the engine in your Jeep cranks (turns over) but it doesn’t start (run). The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc.
What kind of ignition system does a Jeep Cherokee use?
The ignition system is the one tasked with creating and delivering spark to each of the 6 cylinders. Without spark, the engine will crank but no start. The ignition system of the Jeep vehicles covered by this tutorial use either a distributor type system or a COP (Coil-On-Plug) ignition coil system. Failed ignition coil.