What to do with a Nissan Sentra cylinder head?
Heat cylinder head to 110 to 130В°C (230 to 266В°F) by soaking in heated oil (A). Cylinder head contains heat. When working, wear protective equipment to avoid getting burned. Provide valve seats cooled well with dry ice. Press-fit valve seat into cylinder head.
How to remove the front wheel sensor on a Nissan Sentra?
1 Remove the wheel sensor bolt. Position the wheel sensor and the wheel sensor harness aside. Refer to BRC-106, “FRONT WHEEL SENSOR : Removal and Installation”. 2 Remove the cotter pin from the drive shaft. 3 Remove the nut retainer from the wheel hub lock nut. 4 Hold the wheel hub and bearing using Tool (A). Loosen the wheel hub lock nut.
How to remove the front drive shaft on a Nissan Sentra?
Loosen the wheel hub lock nut. Using a piece of wood and a suitable tool, tap on the wheel hub lock nut to disengage the drive shaft from the wheel hub and bearing. Do not place the drive shaft joint at an extreme angle. Also be careful not to overextend slide joint. Do not allow the drive shaft to hang down without support.
How to install wheel studs on Nissan Sentra?
Place a washer (A) as shown to install the wheel studs (1) by using the tightening force of the nut (B). Check that there is no clearance between the wheel stud and the wheel hub and bearing. Clean the mating surfaces of the wheel hub lock nut and the wheel hub and bearing. Do not apply lubricating oil to these mating surfaces.
How big should the torque be on a Nissan Sentra?
An expert whose answer got voted for 20 times. Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees
When to replace the cylinder head on a Nissan Sentra?
Whenever the size difference between (d1) and (d2) exceeds the limit, replace them with a new one. If reduction of outer diameter appears in a position other than (d2), use it as (d2) point. When performing this inspection, cylinder block distortion should also be checked.
What kind of torque does a Nissan Maxima have?
TORQUE SPECIFICATIONS NISSAN APPLICATION FT-LBS (N-m) AXLE SPINDLE NUT 1986-78 115 (157) 1994-87 ALTIMA, MAXIMA, STANZA, & QUEST 174-232 (237-316) PULSAR, SENTRA, 240SX, & 300ZX 145-203 (197-276) AXLE SHAFT-TO-SIDE FLANGE NUT 240SX & 300ZX NON-TURBO 25-33 (34-44) 300ZX TURBO (BOLT) 51-58 (68-78)
What should the torque be on a Mazda BT50?
Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees You can’t post conmments that contain an email address.