What to do when your status light does not blink?
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
What to do when range indicator light does not go off?
One problem that can occur is when the indicator light stays on and does not go off. When this occurs, check the unit to determine if it is operating normally. Turn off the electric range and then unplug the power cord from the electrical outlet. If you cannot access the electrical outlet, turn off the breaker at the circuit panel.
What causes the indicator stalk to turn to the left?
Turn the indicator stalk to the left-hand turn position. If the circuit tester illuminates, the wiring to and inside the switch are okay. If the circuit tester fails to light, it indicates a fault either in the switch itself or in the wiring between the switch and the multi-plug.
Do you move the transmission selector when the car is not moving?
In other words, you’re saying ‘you are not seeing where you’re vehicle is going to” but if you’re “going” when you move that selector, you’re wrong. Period. This is not a manual transmission. We’re talking about moving the selector when THE VEHICLE IS NOT MOVING.
If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.
One problem that can occur is when the indicator light stays on and does not go off. When this occurs, check the unit to determine if it is operating normally. Turn off the electric range and then unplug the power cord from the electrical outlet. If you cannot access the electrical outlet, turn off the breaker at the circuit panel.
Can a bad signal switch cause a blinker not to work?
A faulty signal switch can’t send a signal to the blinkers to work. Sometimes the problem may lie in the wiring, or in the switch itself. If the problem lies with the switch then it’s likely getting stuck in position due to the clock-spring. Regardless, the problem isn’t the blinker itself, but the device that communicates with it.
What to do if your blinkers don’t work?
If the bulb in your signal dies, then it’s a pretty straightforward fix — simply replace it with a new one. Turn signal lights usually last a few years, but they can die quicker if you use them often. The turn signal switch is the device near your wheel which controls your signal. A faulty signal switch can’t send a signal to the blinkers to work.