What to do when your Silverado Sierra dies?
I’ve tred different its hard to scan when runs for 2seconds time. The keys might need to be relearned into the factory system. My old Jeep would do the same thing. One thing to try. Turn the ignition to the on position. This is the position where all the lights and icons are on in the dashboard but don’t start the car. Attempt to start the engine.
What to do if your GMC Sierra won’t start?
Attempt to start the engine. If it doesn’t start then release the key back to the on position. Watch the security light. After 10 to 15 minutes the security light should turn off. Turn the ignition off and wait 5 seconds. Repeat steps 1 through 4 two more times for a total of 3 cycles (30 minutes).
Why does my GM Truck start then die?
He was thinking fuel pump or fuel filter. He was about to take it to a dealer to be checked out when someone told him to turn the key to the on position and leave it there until the dash lights went out then start the truck. He did this and says the truck is running fine now. It reset the security system.
What to do if your Chevy Silverado starts and runs?
You can reset the passlock system (takes about 30 or 40 mins) this will usually fix the problem however it will usually do it to you again at the absolute worst possible times. You can bypass the security system completely and never worry about the problem again. You will not have a security system in your vehicle once it is bypassed.
He was thinking fuel pump or fuel filter. He was about to take it to a dealer to be checked out when someone told him to turn the key to the on position and leave it there until the dash lights went out then start the truck. He did this and says the truck is running fine now. It reset the security system.
Attempt to start the engine. If it doesn’t start then release the key back to the on position. Watch the security light. After 10 to 15 minutes the security light should turn off. Turn the ignition off and wait 5 seconds. Repeat steps 1 through 4 two more times for a total of 3 cycles (30 minutes).
I’ve tred different its hard to scan when runs for 2seconds time. The keys might need to be relearned into the factory system. My old Jeep would do the same thing. One thing to try. Turn the ignition to the on position. This is the position where all the lights and icons are on in the dashboard but don’t start the car. Attempt to start the engine.
You can reset the passlock system (takes about 30 or 40 mins) this will usually fix the problem however it will usually do it to you again at the absolute worst possible times. You can bypass the security system completely and never worry about the problem again. You will not have a security system in your vehicle once it is bypassed.