What sound does an airbag make when it deploys?

What sound does an airbag make when it deploys?

An airbag can generate a sound pressure of 178 decibels, which is over 20% higher than the level that can cause permanent hearing loss. And, more than 90% of individuals will be at risk for hearing disorders when airbags deploy.

How loud is a airbag?

Noise associated with airbag deployment varies with the type of airbag. Deployment of a driver side only airbag will generate mean peak sound pressure level (SPL) of approximately 160 dB, a passenger side only airbag will generate mean peak SPL of 168 dB and dual airbags create a mean peak SPL of 170 dB.

What should I do if my air bag bottomed out?

Rubber flex member was pinched between two ends of air bag. Insufficient pressure in air bags for load. Replace air bag and increase pressure. Work your way down to desired result. For motorhomes, start at 100 psi. Air bag bottomed out. Air bag is suspension limiter in compression.

How to reset an airbag light you it still runs?

Start the engine. The SRS light should come on for seven seconds, and then shut off and stay off. The airbag light has been reset. If you continue to drive your vehicle with the SRS light illuminated, you may risk an accidental deployment of the airbag. “How To Use Automotive Diagnostic Scanners (Motorbooks Workshop)”; Martin; 2008

How to replace an air bag on a flex member?

Replace air bag. Flex member rolled into mounting hardware. Improperly installed. Correct the installation and replace the air bag. Rub mark on air bag. Bag leaks. Replace air bag. Insufficient clearance around air bag. Check for alignment and adjustment of air bag to frame or tire. Re-adjust away from frame or tire.

How to troubleshoot an air lift with tech support?

Inspect entire length of air line for damage or melted air lines. Replace as necessary. Check air bag for massive leak or hole. Call Tech Support at 1-800-248-0892 if the actions do not work. Air spring will not hold air (more then 2-3 psi/week). Check to make sure the schrader valve is tight. Flex member is pulled away form the crimp.

Posted In Q&A