What size are my drawer slides?
Measure from the back of the drawer-front to the end of the drawer box. Only measure the box, do not include the drawer front. Round the measurement off to the lower number on the tape. For example, when the measurement is 22 1/2 inches, you need to purchase 22-inch drawer slides.
Where are Knape and Vogt drawer slides made?
KV craftsmen meticulously produce the ultimate in smooth, quiet drawer slide operation, designed and built to exacting specifications and marketed from our state-of-the- art base in Grand Rapids, Michigan.
Can drawer slides be shorter than drawer?
You should always use the longest slide possible for your application, without exceeding the drawer depth into the cabinet. The Height of a Drawer Slide is usually only a limiting factor, in the sense that you can’t install a slide that is taller than your drawer or pull-out.
How much clearance do you need for drawer slides?
Required clearance is typically around a ½” between the drawer slides and the sides of the cabinet opening and generally the only downside to a side-mount drawer slide is that they will limit the horizontal width of your drawer.
What is drawer Knape?
Knape and Vogt or “KV” hardware is a line of full extension drawer guides that allow the drawer to emerge completely out of the cabinet. These levers prevent the drawer from coming all the way loose from the mounting hardware.
Why are my soft close drawers hard to open?
The primary reason for self-closing drawer failure is improperly installed guides or a drawer that was built out of square. This can cause the drawer to skew to one side and fail to close all the way. You can adjust this type of drawer using only a screwdriver.
How much clearance do you need for undermount drawer slides?
Undermount slides are ideal when horizontal space is limited because they typically only require 3/16″ to 1/4″ of space per slide. The other thing to note about under mount slides is that they require ½” of clearance above and below the drawer in the cabinet opening.
Can you cut a drawer slide?
Use a Hacksaw to Cut Drawer Slides to a Length Needed for a Project! I just whipped out the hacksaw and cut the drawer slides to the length I needed. The roller slides are inexpensive, and generally the home improvement stores only carry them in certain lengths – usually 14″ to 22″.