What should the Lo needle be at full throttle?
Set the needle just to the rich side of halfway between rich and lean. Test the machine. If it shows bogging at full throttle, richen slightly more. Acceleration and idle are governed by the Lo needle. If either is poor, allow the machine to idle for a bit. Go to full throttle.
Why does my train stop and wont restart?
Sitting in the leading engine you hear engine sound from the trailing unit. Have both engines steam from the exhaust? Maybe the leading engine stalled in your hard breaking. You may have to restart the engine. I am new to this program and have the same problem.
What happens when the engine cuts off on a Harley Davidson?
The speedometer needle goes slowly back down while the bike slows down. there is no engine sputtering. i have to pull over and it starts up again. Hey noticed 1st post, welcome to the forum.
Why does my train stop at 25 mph?
I have had this issue twice now and am not sure what is going on. Last night I was descending downhill at 35 MPH and didn’t notice the speed reduction to 25 MPH until my speedometer indicator turned red. I slowed down fairly rapidly and then released the brakes when I got to 25.
Set the needle just to the rich side of halfway between rich and lean. Test the machine. If it shows bogging at full throttle, richen slightly more. Acceleration and idle are governed by the Lo needle. If either is poor, allow the machine to idle for a bit. Go to full throttle.
Why does my car shut off after a sharp turn?
You may notice that every time you drive over a bump on the road or take a sharp turn, the radio, lights and engine suddenly shut off. This is not only frustrating but a safety issue. After a few minutes, the engine and the rest of the electrical accessories may start working again.
The speedometer needle goes slowly back down while the bike slows down. there is no engine sputtering. i have to pull over and it starts up again. Hey noticed 1st post, welcome to the forum.
Why does my car stall at low rpm?
The will likely force your computer to stall the engine and only allow it to run at low RPMs, which means the car will only move at slow speeds. This is a safety feature enforced by the computer so that your engine doesn’t get too damaged.