What should I do if my Vito engine is not working?
The outlet pipe on the small low pressure pump at the front of the cylinder head should be removed and the engine should be cranked over until the fuel flows out 3. Next the pipes can be refitted and the high pressure pipe at the high pressure pump outlet or at the fuel rail should be cranked again until the fuel flows out
Why does my Vito CDI 110 2000 shut off?
Hi My Vito CDI 110 2000 has Shut off Fault Code, Boost Pressure Code. 7.5a ECU Fuse causes grey smoke rough running when inserted. Merc Star Can not communicate with the CDI. Van starts and runs ok without the 7.5a fuse but in limp mode. Help.
Why does the Mercedes Vito go into limp mode?
Why does the Mercedes Vito van (112 CDI 638 chassis) go into limp mode after climbing over a long hill or while under load? The vacuum transducer and turbo pressure sensor were changed. There are a variety of reasons which can result in the Mercedes Vito engine going into a limp mode.
Where can I get a new EIS for my Mercedes Vito?
I rang Mercedes parts department in Milton Keynes (Very helpful) and was told a new EIS is 350 sterling. You’ll need a green/orange programming key from mercedes which looks like a slimmed down version of your key but i think its just a usb.
What causes the Mercedes Vito to go limp?
Under-boost can be due to several factors such as intake system air leaks, blocked catalytic converters, EGR problems, and vacuum problems and so on. Since the Mercedes Vito tends to go limp while going uphill, it can be a symptom of blocked catalytic converters. Listed above are some of the Mercedes Vito problems.
How do you remove a fuel pump from a tank?
Pull the fuel hose straight back from the pipe. If you remove the stopper from the quick connector, do not lose it. Cover both ends of the fuel pipe and line to keep foreign material out. Loosen and remove the bolts circling the top of the fuel pump unit. Pull the fuel pump module from the tank.
What kind of Van is the Mercedes Vito?
Enjoy! Mercedes Vito The Mercedes-Benz Vito is a light van produced by Mercedes-Benz. It is available as a standard panel van for cargo (called Vito), or with passenger accommodations substituted for part or all of the load area (called V-Class or Viano).
How do you replace water pump on Vito 111 CDI?
The fan shroud and the fan must be removed to get to the pump. To remove the shroud, intercooler must be removed. To do that, bumper must be loosened on both sides. Radiator does not need to be removed. Regards, Stan Ask Your Own Mercedes Question Was this answer helpful? Yes No Finish How JustAnswer works
The outlet pipe on the small low pressure pump at the front of the cylinder head should be removed and the engine should be cranked over until the fuel flows out 3. Next the pipes can be refitted and the high pressure pipe at the high pressure pump outlet or at the fuel rail should be cranked again until the fuel flows out
Enjoy! Mercedes Vito The Mercedes-Benz Vito is a light van produced by Mercedes-Benz. It is available as a standard panel van for cargo (called Vito), or with passenger accommodations substituted for part or all of the load area (called V-Class or Viano).
Why does the Mercedes Vito van (112 CDI 638 chassis) go into limp mode after climbing over a long hill or while under load? The vacuum transducer and turbo pressure sensor were changed. There are a variety of reasons which can result in the Mercedes Vito engine going into a limp mode.