What should I do if my Hyundai Veloster has a leak?
Let the adhesive dry for at least one hour, then spray water over the roof and check for leaks. If a leak occurs, let it dry, then seal with sealant : Let the vehicle stand for at least four hours after windshield installation. If the vehicle must be driven within 4 hours, it must be driven slowly.
How to replace movable glass on Hyundai Veloster?
Movable glass Replacement 1. Open the movable glass fully. 2. After loosening the mounting screws, then remove the movable glass (A). Do not damage the screws. 3. Installation is the reverse of removal. Motor Replacement Confirm the position of guide whether it is closed or not when you remove the motor. 1. Remove the roof trim.
How to replace the panoramaroof on a Hyundai Veloster?
1. Open the movable glass fully. 2. After loosening the mounting screws, then remove the movable glass (A). Do not damage the screws. 3. Installation is the reverse of removal. Motor Replacement Confirm the position of guide whether it is closed or not when you remove the motor. 1. Remove the roof trim.
Can you put body primer on a Veloster?
Apply a light coat of glass primer to the outside of the fasteners. Never touch the primed surface with your hand. If you do, the adhesive may not bond to the glass properly, causing a leak after the windshield glass is installed. Do not apply body primer to the glass.
Do you have to replace the O-rings on an AC condenser?
The next step will be to replace the o-rings on the AC lines going to the condenser. Note: These o-rings can only be used one time and must be replaced or your system will leak. Coat the the o-rings with the system oil to ensure a good seal. Once the o-rings are replaced the lines can be bolted back to the condenser.
What should I do when my AC condenser is removed?
Before the AC condenser is removed from the vehicle the AC lines must be removed. Wear eye protection and preferably a face shield when removing refrigerant lines in case any residual pressure remains. Keep in mind the system contains (or contained) not just refrigerant but also refrigerant oil which could spatter in your face.
Where does the yellow hose go on an AC condenser?
The yellow hose will go to the recovery machine. From the recovery machine this will go into a recovery tank. The blue hose will go to the low side (20-50 PSI in operation) pressure port. The red hose will go to the high side (175-300 PSI in operation) pressure port.