What should I do if my ABS sensor goes bad?
1. Bend the wire gently as you go along. A damaged section should kink with little resistance. 2. Failing that, as a last step, you can gently cut a part of the insulation and measure the resistance (using a multimeter) from the connector to the cut part of the insulation.
Where is the ABS sensor on a Saab?
The first goes from the engine bay to a small connector box on the right hand side (from the back of the car) near the fuel tank. The second half goes from this box, splits about 30-40cm into two seperate looms, one for each wheel.
Can you pull ABS code with standard OBD scanner?
This is my first how-to guide I’ve written, so any feedback on it is most apriciated! My ABS+traction+stability control packed up last week and flagged up a error code. The ABS error code can’t be pulled with a standard OBD scanner, you need either an offical GM Tech2 or alternatively an op-com.
How much does it cost to fix ABS fault on Saab?
As a final step you may need to clear the ABS fault code from the ABS module using op-com/tech 2. However this isn’t compulsory as the system will operate fine. I hope this helps anyone who comes across this problem in their Saab. Total repair cost: £2.79.
What to do if ABS wheel speed sensor goes out?
If the ABS wheel speed sensor was faulty, once the new hub/sensor is installed, and you drive the vehicle, the warning lights should go out. To determine what is going on, you can manually erase the trouble codes using an appropriate scan tool and if the warning lights stay off, then the problem is resolved.
Why is the ABS light still on after 15 mph?
According to the service manual, the ABS light will clear after all sensors register 15 MPH. If the light is still on, there’s still a problem somewhere. I am beginning to wonder if the ring on the hub may be at the root of some of these problems.
How much does it cost to change ABS sensor?
I just changed a faulty front ABS wheel sensor on my 2001 chrysler voyager, I posed a thread earlier this year explaining how to test the sensors. Anyhow the new sensor cost me $36 from Ebay (USA) and when I fitted it the light went off after approx 1/4mile of driving.
This is my first how-to guide I’ve written, so any feedback on it is most apriciated! My ABS+traction+stability control packed up last week and flagged up a error code. The ABS error code can’t be pulled with a standard OBD scanner, you need either an offical GM Tech2 or alternatively an op-com.