What should I change in my Yamaha Grizzly no spark?
We changed out the CDI box, ignition coil, new plug. We have a Yamaha service manualand checked everything, resistance on factory specs and also the ones for stator and pickup provided by Ricky Stator.
Why are the wires on my Grizzly no spark melted?
Pulled out the stator the wires were melted together right before the grommet where the wires exit the case. Called Ricky Stator. They said it could be that the rectifier went bad and then there was nowhere for the current to go and it melted wires together. Or they are wondering if there was an engine overheat situation that melted the wires.
How many volts does help 600 Grizzly no spark have?
We cleaned the grounds and untaped the wiring harness and checked the ground crimps on the harness. We also did a point by point amptest by putting 2.5 amps through each wire to check for corrosion and broken strands. All that checked out fine. The source coil is putting out 91 volts.
Is there a service manual for a Yamaha Grizzly?
We have a Yamaha service manualand checked everything, resistance on factory specs and also the ones for stator and pickup provided by Ricky Stator. Everything checks out fine. We cleaned the grounds and untaped the wiring harness and checked the ground crimps on the harness.
Why does my Grizzly 600 have no spark?
do you have power to the coil from the cdi box. if you do not get some kind of crank signal from the cdi box then your coil will not spark. remove the plug wire and try to starting it. see if the coil arcs to itself. most will. if it does then put a new plug and wire on it. What year is your Grizzly?
Why does my Yamaha Kodiak have no spark?
The main switch on the handlebars is a negative switch, so would be no power for the on/off or start button. The cdi box is brand new and it does not have 12 volt power (red wire) going to it. I thought it would get DC current from the pickup or stator could but i am not reading any, and thats with the old stator and the new rm stator.
We have a Yamaha service manualand checked everything, resistance on factory specs and also the ones for stator and pickup provided by Ricky Stator. Everything checks out fine. We cleaned the grounds and untaped the wiring harness and checked the ground crimps on the harness.
Is the CDI box on a new Kodiak?
The cdi box is brand new and it does not have 12 volt power (red wire) going to it. I thought it would get DC current from the pickup or stator could but i am not reading any, and thats with the old stator and the new rm stator. It does read AC current thou.
What’s the problem with my Grizzly 600 ATV?
The problem appeared while running down a level dirt road at 50 Km/hr and then the ATV just quit running. I coasted to the roadside, stopped and restarted the ATV right away. I then drove another 20 K when it once again quit running while going down a hill, I stopped once again to restart the ATV but she won’t stay running.
Why does my Yamaha 600 Grizzly have no spark?
Had no spark. We tested and found it was the stator, changed the stator with one purchased from Ricky Stator. It ran fine about 4 hours while snow plowing and it died again. Again, no spark. We changed out the CDI box, ignition coil, new plug.
What should the stator measure on a Yamaha 600 Grizzly?
The stator should measure little to no resistance within the coils, but from coil to ground on the engine should be nothing or it would be a grounded stator = no good. If you had a grounded stator it could have grounded the ignition system, but it would have also killed the battery.
What to do if your Grizzly has no spark?
Just wondering. Location: Iowa!!!!! Try going to your kill switch, pull the wires and check continuity across the contacts. Then go to your tranny switch for the neutral safety, pull the wires and hot wire across the two ends = make sure it’s in neutral. See if that gets you a spark.
The problem appeared while running down a level dirt road at 50 Km/hr and then the ATV just quit running. I coasted to the roadside, stopped and restarted the ATV right away. I then drove another 20 K when it once again quit running while going down a hill, I stopped once again to restart the ATV but she won’t stay running.