What should coolant temp be on C13 engine?
Two separate sensors. fan will cut in at 103 deg C engine coolant temp 73 deg C inlet air temp and when ever cyled by the air con. Generally I value 5V analog data higher than a 2 wire thermal resistor.
What to do about engine oil in coolant?
I have an engine here with so much engine oil in the coolant that rad is plugged. Tested the head gasket on the air compressor and there is a small leak, so we’ll replace the compressor. I removed the oil filter and pressurized the cooling system. Water came pouring out of the filter housing, so I’m going with the oil cooler.
How does the ECM work on a C13?
On an 05, the dash and ECM get info from different sensors. Need an infrared gun to verify which one is correct first. A5¢ Thanks this. A5¢ Thanks this. A5¢ Thanks this. Both temp sensors while be on thermostat housing on a C13. Cat one will be hooked to cat harness/mesh style covering that is tougher than steel to cut.
What are the temp sensors on a C13?
A5¢ Thanks this. Both temp sensors while be on thermostat housing on a C13. Cat one will be hooked to cat harness/mesh style covering that is tougher than steel to cut. Pete harness will have convulted plastic split loom.
How to troubleshoot a temperature gauge in a car?
Temperature gauge troubleshooting begins with isolating the problem either to the gauge, sending unit, fuse or wiring. As with any electrical troubleshooting it is best to check all wiring connections are clean, tight and free of corrosion. The following process must be preformed with the ignition key turned to the “on” position.
How can I tell if my light gauge is hot?
Check the gauge if the needle moves toward “Hot”, the wire from the gauge to the sending unit has an open or bad connection. If it does not move, connect a test light by grounding one end to a good known ground and the other end to positive side of the gauge (typically a pink wire).