What should be the multimeter reading of a good fuse?
Place the multimeter on the ohmmeter setting and place the probe leads across the 2 ends of the fuse. If the reading you get is very low, a few ohms, then the fuse is continuous and, thus, good. If the reading is get is very high, such as severeal Megohms, the fuse is broken and, thus, bad, and should be replaced.
What happens when you test a fuse with a multimeter?
Next, put one lead on each end of the fuse and check the reading. If the reading is close to the one you got when you touched the positive and negative leads, the fuse is fine. If the fuse is blown, the meter will not read anything at all, or the meter may say “Open Loop” or “OL.”.
Can a fuse be replaced with a lower rating?
Never replace a blown or suspect fuse with one of a higher rating. The rating ensures that the current can pass through the wiring safely. Always replace a fuse with the same rating as (or a lower rating than) the old one. Thanks! Never test a fuse on equipment that is still on.
What happens when a fuse is blown on a meter?
If the reading is close to the one you got when you touched the positive and negative leads, the fuse is fine. If the fuse is blown, the meter will not read anything at all, or the meter may say “Open Loop” or “OL.” If you want to use the meter as an ammeter, keep reading! Did this summary help you?
What should the resistance of a fuse be?
If you want to make sure, remove the battery terminal, and use an ohmmeter to measure the resistance between the battery terminal and the other side of the fuse. Should be zero or close to it. If so, it is good. With this type of fuse, when it blows, there is usually a large gap due to the amperage it takes to “blow” it.
What happens if you replace a fuse with a higher amp fuse?
If you replace a fuse with a higher amp one it will work but create an unsafe circuit. It could cause a failure of the device burn it up, start a fire. The fuse is designed as a safety device. It should not only be the correct amperage but also the correct voltage and fast or slow blow.
What was the fuse that blew on my AM2?
Naturally I checked the fuses and the AM2 fuse was blown. It’s normally a 30A fuse and I temporarily replaced it with a 20A fuse just to try. The engine started up fine and I let it run for about 5 minutes. I shut it off and went to the hardware store to buy some 30A fuses.
What’s the best way to test a fuse?
Place the fuse on a non-conducting surface such as wood, laminate or plastic. Touch the metal caps at each end of the fuse with the metal tips of the testing leads. There is no polarity so you can use any lead for either fuse cap.
Next, put one lead on each end of the fuse and check the reading. If the reading is close to the one you got when you touched the positive and negative leads, the fuse is fine. If the fuse is blown, the meter will not read anything at all, or the meter may say “Open Loop” or “OL.”.