What kind of roller should be used to apply Raptor?
Care must be taken when applying with a roller because softness will occur if RAPTOR is applied too thickly. Make sure that a medium coat is applied with the roller so that the RAPTOR can cure and harden so scratch resistance will still be maintained. What type of roller should be used to apply RAPTOR?
What’s the best way to remove Raptor paint?
RAPTOR is a coating made to last, so it is difficult to remove once cured. Once RAPTOR is cured, remove by sanding it off with P80 grit sandpaper either down to the original substrate or to bare metal. Then, respray the surface with another coating, like OEM paint colors (required).
When to paint over tigerseal with Raptor paint?
If using a different sealant to Tigerseal, paint over with RAPTOR as early as TDS allows (preferably within 1 hour), it should be noted that full adhesion may not develop with some sealants for some time after painting with RAPTOR. 2.
How is the durability of a raptor determined?
The durability of RAPTOR is strongly linked to its high film build. By adding reducer the film build will decrease and therefore some of its durability characteristics will decrease, although only slightly. Can you apply RAPTOR to wheel rims?
RAPTOR is a coating made to last, so it is difficult to remove once cured. Once RAPTOR is cured, remove by sanding it off with P80 grit sandpaper either down to the original substrate or to bare metal. Then, respray the surface with another coating, like OEM paint colors (required).
Which is the best ring and pinion gears?
Maximize drivetrain performance with premium ring and pinion gears from the industry’s top ring gear and pinion manufacturers. Summit Racing offers ring and pinion gears in all of the ratios, diameters and spline counts you’re looking for to complete your build.
How to prepare bare metal for Raptor application?
Preparation How do you prepare bare metal for a RAPTOR application? Scuff surface with 80-180 grit sandpaper and apply 1-2 coats of RAPTOR Acid Etch Primer (UP5023). Allow to dry for 15-20 minutes before applying RAPTOR.
Care must be taken when applying with a roller because softness will occur if RAPTOR is applied too thickly. Make sure that a medium coat is applied with the roller so that the RAPTOR can cure and harden so scratch resistance will still be maintained. What type of roller should be used to apply RAPTOR?