What kind of engine problem does Toyota Tacoma have?
My 2006 Tacoma with same engine and transmission had none of these noises. Metallic tapping noise coming from engine at idle and under load at very low RPM. They reflashed the ECU. Probably a TSB for running too lean.
What kind of transmission does the Toyota Tacoma have?
The X-runner comes only with an Aisin RA60 6-speed manual transmission produced by Aisin Seiki Co. Production numbers are unknown but it is believed roughly 3,000 X-runners were made each model year. This section contains content that is written like an advertisement.
When did they start working on the Toyota Tacoma?
Development began in 1989, following launch of the fifth-generation Toyota Pickup in late 1988 and concluded in 1994. Design work was done at Calty Design Research in California from 1990 to 1992, when Kevin Hunter’s exterior design proposal was chosen in the autumn of 1991 and in final form,…
How much horsepower does a Toyota Tacoma have?
1 2.4 L four-cylinder rated at 142 hp (106 kW) and 160 lb⋅ft (217 N⋅m) of torque 2 2.7 L four-cylinder rated at 150 hp (112 kW) and 177 lb⋅ft (240 N⋅m) of torque 3 3.4 L V6 rated at 190 hp (142 kW) and 220 lb⋅ft (298 N⋅m) of torque
Can you change the crank position sensor on a Toyota Tacoma?
Neither Toyota, nor your dealer, needs to know you changed it. Hank Heel, shakerhood and cshrum like this. Clearwater Bill Sometimes when I close my eyes, I can’t see. Click to expand… Lesson learned should be to leave stuff alone, especially when in warranty. Let them fulfill their obligation to fix the vehicle.
How long does it take to replace a sensor on a Tacoma?
If you have the new sensor, just replace it yourself at this point, rather than arguing with the dealer. It’s a 20 minute job, which includes removing the wheel, which is optional, but I found it to be helpful to have it out of the way. Remove the sensor from the block then remove the wiring connector.
Why is my Toyota Tacoma making a noise?
They cleaned off the front of the motor from all the lube they sprayed before, then they couldn’t locate which idler pulley is making the noise because the water lubed it good enough to stop squeaking. Noticed engine noise during heavy acceleration during hot weather. A TSB was issued for this problem .