What kind of engine does a Revcon motorhome use?
Production started in Fountain Valley, California, with the 1972 model using the Oldsmobile Toronado 455 engine and drive system. By the end of the 1970s, however, Olds had downgraded its drive systems, which were no longer suitable for motorhome use, so Revcon designed its own front-wheel drive system using the Chevrolet 454 engine.
What kind of fan clutch does a GMC 500 CID use?
Hayden # 2747 fan clutch or AC Delco #15-4208 can be used along with the original GMC fan blade. 4. NAPA # TS-6469 water temp sensor/sender. The “horse collar” (i. e. the shroud found on the back side of the radiator in 73-76 GMC models) was removed and cut to make it a two-piece unit for easier servicing in the future.
What kind of engine does a Cadillac 500 have?
1968-74 RWD Cadillac* 472 1975-76 RWD Cadillac* 500 1970-76 FWD Eldorado 500 * – Refers to full size cars and excludes Seville’s. Note:There is a General Engine Specifications table at the end of this document that contains further data on Caddy engines from 1968 thru 1976 that may be of interest to you.
What kind of engine does a gmcmi motorhome have?
A four speed manual front wheel drive transaxle was used to eliminate a driveshaft tunnel that would have increased height or diminished interior headroom. Early units used a Chrysler 225ci industrial slant-6 engine. In 1969 a V-8 engine was introduced, using a Ford 302ci engine but still using the 4-speed manual transaxle.
Production started in Fountain Valley, California, with the 1972 model using the Oldsmobile Toronado 455 engine and drive system. By the end of the 1970s, however, Olds had downgraded its drive systems, which were no longer suitable for motorhome use, so Revcon designed its own front-wheel drive system using the Chevrolet 454 engine.
Hayden # 2747 fan clutch or AC Delco #15-4208 can be used along with the original GMC fan blade. 4. NAPA # TS-6469 water temp sensor/sender. The “horse collar” (i. e. the shroud found on the back side of the radiator in 73-76 GMC models) was removed and cut to make it a two-piece unit for easier servicing in the future.
Where are the mounts on a GMC Caddy?
You will have to drill new holes in the GMC front crossmember to locate the Caddy mounts. The new holes are approximately 3/4 ” forward and 1 1/2” to the right of the original. The far rear mounts are on the transmission and will bolt to the original GMC location. The front motor mount will probably be bad when you get it.
What kind of car is a GMC Royale?
Unlike most of the GMC motorhomes we feature, this Royale model actually looks quite tidy and has been extensively used as intended by its two owners.