What is the torque for Jeep Wrangler wheels?
Jeep Lug Nut Torque Specs Recommendations
| Model | Trim | Torque |
|---|---|---|
| WAGONEER | ALL / GRAND | 75 ft-lbs |
| WRANGLER | BASE / SAHARA | 110 ft-lbs |
| WRANGLER – ALL | 17″BASE / RUBICON | 95 ft-lbs |
| WRANGLER | ALL NEW JL UNLIMITED ALL | 130 ft-lbs |
What are the torque specs on a TJ Wrangler?
All TJ Wranglers other than Rubicon models came standard with a Dana 30 front axle. These torque specs come in handy if you are changing differential fluid, rebuilding the axle, or regearing. These specs only apply for the front Dana 44 axle for TJ Wranglers.
Why are all the bolts torqued on a Jeep Wrangler?
When your Wrangler rolled off the factory assembly line, every single nut and bolt of the steering, drivetrain, suspension, and many other areas, were torqued to manufacturer’s specification. The reason for this is that if the bolts were not tight enough they could fall out.
What kind of engine does a Jeep Wrangler have?
The 2.5 liter inline 4 cylinder engine was used from 1997-2002. The successor to this engine was the 2.4 liter version. This engine is one of the most popular engines that Jeep has ever put into their vehicles. The torque specs needed to rebuild this inline six if the need should arise.
What kind of front axle does TJ Wrangler use?
Dana 44 front axles came standard on Rubicon models, it was not available for any other models. The 194 RBI is also called the Dana 35 and came standard in all TJ Wranglers other than the Rubicon. Note: Refer to pinion gear removal and installation procedures for proper pinion nut tightening instructions.
Where can I get torque for my Jeep Wrangler?
Find the aftermarket Wrangler parts you need, at ExtremeTerrain. Remember to torque your Wranlger’s bolts after every modification! When your Wrangler rolled off the factory assembly line, every single nut and bolt of the steering, drivetrain, suspension, and many other areas, were torqued to manufacturer’s specification.
The 2.5 liter inline 4 cylinder engine was used from 1997-2002. The successor to this engine was the 2.4 liter version. This engine is one of the most popular engines that Jeep has ever put into their vehicles. The torque specs needed to rebuild this inline six if the need should arise.
Why did my torque nut snap on my Jeep Wrangler?
If the bolts were over-tightened they could get stuck in the hole, snap, or pull the threads out. During routine maintenance and after doing any kind of modification to your steering, suspension, or drivetrain, all bolts and nuts should be checked to ensure that they have been tightened to specification.
What’s the gear ratio on a TJ Wrangler 4WD?
The NV231 is also commonly referred to as Command-Trac. It is a shift-on-the-fly part time 4wd transfer case. This transfer case has a 2.72-1 gear ratio in 4-Low. The NV241 is a shift-on-the-fly part time 4wd transfer case. This transfer case has a 4-1 gear ratio in 4-Low.