What is the red key light on a Harley Davidson for?
The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed.
Why do the lights keep flashing on my Harley Davidson?
It’s when the fob is out of range and the bike is “disturbed” a bit and the security activates by flashing the lights like it is supposed to do but the dang lights just keep flashing till I get my fob out of the house and take it close to the bike. Have you tried to turn off the security system and turn it back on.
Why are my turn signals not working on my Harley Davidson?
Changes in temperature, moisture and dust are some of the factors that can cause this to happen. Our bikes need some attention after spending a lonely cold winter in the garage.
When do turn signals flash, bike won’t start?
Re: Turn signals flash, bike won’t start, no key fob with… If you turn signal flashing,then your security system is on. You will need the key fob for starting.,or change the Bat on Key Fob. You can’t post conmments that contain an email address.
What should I do if my turn signal is not flashing?
Upgrading the signal flasher resolves the problems associated with LED conversion about 95% of the time. They are the recommended solution to the problem, but they are not the only solution. The other alternative is to add in line load resistors to the turn signal system.
It’s when the fob is out of range and the bike is “disturbed” a bit and the security activates by flashing the lights like it is supposed to do but the dang lights just keep flashing till I get my fob out of the house and take it close to the bike. Have you tried to turn off the security system and turn it back on.
Why is my turn signal not working on my Harley?
These reasons include a dying key fob battery, blown turn signal bulb, or bad fuse. Fixing these problems could lead to the module clearing its own code. Accessing the diagnostics menu requires you to press several of the accessory switches in a very specific manner, within a short amount of time.
Re: Turn signals flash, bike won’t start, no key fob with… If you turn signal flashing,then your security system is on. You will need the key fob for starting.,or change the Bat on Key Fob. You can’t post conmments that contain an email address.
Why is the blinker on my Harley Davidson not working?
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.