What is the manual for a Mazda 626?

MAZDA 626 1993-97 Man Trans GA2B-39-070 6 CYL 6 CYL Auto Trans 4 Cyl 93-94 GE6T-39-070A 95-97 KB31-39-070D 6 Cyl GA2G-39-070C 8 Brkt, Trans Mount Man Trans GA2A-39-080D Auto Trans GA2C-39-080C 9 Mount, Crossmember Man Trans GA2E-39-100A Auto Trans 4 Cyl…

How much does it cost to change the transmission on a Mazda 626?

Same as the diagnosis test done at Mazda last week cost me $300 instead of $79.95 as the mechanic had to do all these tests and take it out for a test drive – the hours were counted and I had to pay to find out it was the transmission – and after all that – transmission is ok – it was the Transmission Range Switch which needed to be changed.

What happens when the light goes on on a Mazda 626?

When the light goes on, it enters a Fail-Safe mode (the EPC solenoid opens up and brings line pressure up to ‘max’) the only catch is it raises the fluid pressure well beyond normal specs (it goes from 100 to 400 PSI). It is at this time where you get your major failures.

What is TSB 05-005 / 02 for Mazda 626?

TSB 05-005/02 deals with one specific circumstance: “After extended highway driving, the O/D off light is blinking and code P1783 is set (excessive ATF temperature). Occasionally there will be overflow through the dipstick tube and harsh shifting.

How to get code 111 on Mazda 626 probe?

So for Mazda 626 owners you can completely skip Step 6, for other vehicles owners (not Mazda 626, MX6, Probe, or Telstar) with EEC-IV that stumble upon this article in the future, step 6 might apply to you. 7. After a pause of about 4 to 15 seconds if everything checks out OK, you should receive a code “111.”

How many times does a Mazda 626 pulse?

For example, on a 2.0L Mazda 626 it will pulse two times, on a 2.5L V6 it will pulse three times. (Equus 3145 code reader correctly deciphers it for you and displays 4 for a 2.0L and 6 for a 2.5L). 5. Make sure your steering wheel is straight prior to beginning step 5.

Can a Mazda 626 request a WoT response?

In my experience so far, the Mazda 626 with EEC-IV does not request the WOT response prior to KOER codes. So for Mazda 626 owners you can completely skip Step 6, for other vehicles owners (not Mazda 626, MX6, Probe, or Telstar) with EEC-IV that stumble upon this article in the future, step 6 might apply to you.

Navigation