What is the fault code for Eaton SMARTSHIFT?
Eaton Autoshift/ Smartshift/ Autoselect transmission Fault Codes list Fault code SID Imf Decoding 11 254 2,12 Internal malfunction of the device ECU 12 233 12 Gearbox ECU 13 236 4,5 Winding of the Power relay 14 18 12 Gear shift Lever
What is the transmission fault code on an Eaton Fuller?
Eaton Fuller/ Autoshift/ Smartshift/ Autoselect Transmission Fault Codes & Eaton RTAO-1X710-AS / RTAO-1X710-AC / RTLO-1X918-AS
Where are the fault codes on a Mercedes Benz?
Cut off line to Pin 11 (BNYE), Pin 12 (BU) and line to Pin 4 (YE) approx. 160mm after the connector (14-pin) of the frame floor system (FFS) wiring harness to the steering column tube (N80) and unpin from steering column tube module connector. Slide back the flexible cable set jacket and fix in place for this purpose.
What causes error code p0105 map, circuit malfunction?
A P0105 DTC could be caused by: MAP sensor vacuum hose disconnected or plugged Short to reference voltage on signal circuit of MAP sensor Using a scanner or code reader, turn the ignition on and engine OFF; what does the MAP sensor voltage read? It should be about 4 Volts for sea level.
Where is the fault code on a Mack truck?
Read below to learn how to test, clear and fix fault code errors for your Freightliner, Mack, Peterbilt, Kenworth, Volvo and International truck. The Input Shaft Speed Sensor is located on the 6-bolt PTO Cover, which is standard on the right side of the transmission.
Is there charge for Eaton Fuller Autoshift service?
There is no charge for this service, but standard message and data rates may apply. My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear.