What is the fan override switch for?
Hear this out loudPauseThe fan override option allows you to turn on the cooling fan during extreme riding conditions. This assembly will also allow the user to let the fan run on it’s normal cycle when the switch is in the center position and you will also be able to turn the fan off with the switch in the bottom position.
What does fan override mean?
Hear this out loudPauseIf the vehicle is equipped with a manual fan override switch, the operator may activate the fan at 100% fan speed at any time. Two-Speed Fans – By avoiding the constant ON-OFF fan cycle, the Two- Speed Fans could deliver some advantages, such as efficient performance and longer life cycle of FAN clutch.
Can Am Commander cooling fan override?
Hear this out loudPauseThe fan override allows the operator to manually turn ON the cooling fan at will or with the switchable OFF feature you’ll be able to turn the fan ON & OFF depending on the switch option ordered.. Stock fan operation still works as it would normally.
What does fan OVRD mean?
Hear this out loudPauseIf the BLOWER button is in OVRD, the blower fan is stopped. This is similar to open-circuit except the intake air is provided by the air-conditioning rather than from outside the aircraft and the blower fan is stopped.
What is override switch on Can Am Commander?
Hear this out loudPauseThe override button on your multi-function switch, overrides the rpm limiter function when riding in reverse, so you are able to have full throttle, otherwise the rpm is limited when driving in reverse.
How do you disconnect a fan override switch?
Use pliars to pull up the tab in the middle of the plug and it will pop right out without breaking. Now you can lift up that end of the fuse box. To disconnect the bottom, use a flat screwdriver to release the tabs all around it. With the bottom off, look for the green wire going to the fan relay.
What kind of wire to use for a fan override switch?
If you get a resistor with larger leads, you can use butt connectors and crimp it together just as I instruct for the diode. 18 gauge wire. Enough to run from your fuse box under the hood to wherever you want to mount your switch, and a bit more to run a ground from your switch. 18 gauge is the smallest wire I use for any wiring projects.
When to remove solder from a fan override switch?
After about 3 or 4 seconds, touch the solder to the wire and lead. It should liquify and run across them. Remove the solder and iron immediately and don’t touch the wire for 20 seconds or so, to allow the solder that melted to it to harden.
What is the voltage of the Selenoid on a Freightliner Century 98?
Discussion in ‘ Freightliner Forum ‘ started by crosstown, Jul 18, 2011 . have freightliner century 98 with detroit 60 and radiator fan runs continuously. The voltage to the selenoid is 0 v when harness connected and it is 13.7 v when disconnected.