What is the error code on a Yamaha?
Error codes Yamaha R1. Explanation and diagnosis. 1. Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector. 3. Simultaneously press SELECT + RESET on the dashboard and not let go. 4.
How to check Yamaha motorcycle fault code DTC?
Error codes DTC of Yamaha Motorcycle. Explanation and Troubleshooting. To enter the diagnostic mode and check the existing error codes in memory, do the following: 1. Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector.
What are the fault codes on a Yamaha R1?
36 – malfunction of the ignition coil 4 of the cylinder, – is diagnosed by the self-diagnosis line D: 33; 39 – malfunction of the primary injector circuit, – is diagnosed with the self-diagnosis line D: 36.37.38.39; 40 – malfunction of the secondary injector circuit, – is diagnosed by the self-diagnosis line D: 40,41,42,43;
What to do if you have a DIAG on your Yamaha?
Explanation and diagnosis. 1. Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector. 3. Simultaneously press SELECT + RESET on the dashboard and not let go. 4. Turn the ignition switch (button still hold) and wait for about 8 seconds until the dashboard inscription “dIAG”.
What is the fault code for a Yamaha motorcycle?
34 – faulty ignition coil cylinder 2 – self-diagnosed string D: 31; 35 – faulty ignition coil 3 cylinder – self diagnosed string D: 32; 36 – faulty ignition coil 4 cylinder – self diagnosed string D: 33;
What is the DTC code for a Yamaha outboard?
YAMAHA Outboard Marine Engine Fault Codes DTC. 1 – Normal (No Faults) 13 – Incorrect Pulsar Coil Signal. 14 – Incorrect Crank Position Sensor Signal. 15 – Incorrect Engine Temperature Sensor Signal. 17 – Knock Sensor. 18 – Incorrect Throttle Position Sensor Signal. 19 – Incorrect Battery Voltage. 22 – Incorrect Atmospheric Pressure Sensor Signal.
How to check a Yamaha er-3 fault code?
Er-3 – it is impossible to consider the testimony from the ignition module; Login process in diagnostic mode: 1. Switch off ignition. Disable button Start / Stop Engine (red on the right panel). 2. Press both buttons on and keep them tidy. 3. Turn the ignition, hold the button after the ignition is about 8 seconds.
Where can I find the fault code on my Yamaha WaveRunner?
You can find the current faults with details on the ‘Active Faults Tab.’ When it comes to Yamaha fault codes, they are rarely found in one place. For better understanding, we’ve compiled all official Yamaha WaveRunner fault codes into one chart. 86 – Y-COP Immobilizer, Theft Deterrent.