What is the diagnostic warning light on a Mazda 3?
Every time you start your Mazda 3, the computer system runs a self diagnostic check on all major systems. If any of these checks fail, you will see a diagnostic warning light on the dash for the corresponding system. When the airbag system fails this check, you’ll see the airbag light.
When does the SRS airbag control module reset?
Airbag control modules have many common names. They are sometimes referred to as: The SRS airbag control module must be reset if your vehicle was in an accident and the airbag light is on. If the light is on but your vehicle was not in an accident, there are a variety of reasons why this may have happened.
Can a Mazda airbag module be reset by myairbags?
The best part of having your Mazda’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
Why does the airbag light come on on my Mazda 3?
Your Mazda 3’s airbag system is complicated. There can be a lot of different reasons why the airbag light may have come on. Most of them should be left to a professional. Just because the vehicle can be driven, does not mean that the problem should be ignored. If there is anything that you would like to add, please leave a comment below.
Is there a way to reset the Mazda SRS light?
The electronic tool reads the Mazda computer codes and resets the light, although the cost of the diagnostic tool (approximately $1,000) is beyond the reach of most consumers. It is better to pay a mechanic to identify and resolve what could be a serious problem with your air bag safety system than to ignore the SRS light.
How long does it take to reset a Mazda airbag?
MyAirbags is proud to offer SRS Airbag Module Reset and Seat Belt Repair services to get your Mazda back on the road again safely. Avoid the unnecessary expensive dealership prices and trust in MyAirbags to repair and return your airbag module and your seat belts within 24 hours of receiving it, 100% guaranteed or money back!
Where can I find the Mazda DTC trouble codes?
Mazda DTC Trouble Codes DTC Description B1364 Driver Seat Belt Pretensioner Short To P C1946 Seat Track Position Switch Circuit Open C1947 Seat Track Position Switch Circuit Short C1948 Seat Track Position Switch Circuit Resis
Why does my SRS light keep coming on?
Check the fuses in the fuse box under the steering column and replace any that are blown. A bad fuse can cause the SRS light to come on. Disconnect the negative cable from the battery terminal using pliers or a wrench. Leave the cable disconnected for at least 10 minutes.