What is the code for a Jeep Grand Cherokee?
P0340 and P1391 codes-Need suggestions! 2001 Jeep Grand Cherokee Limited, 4.7L, V8, 80,500 miles, all wheel drive. The engine light came on several weeks ago and the first code (P0340) appeared. Shortly after that, it failed to start one time and I had the spark plugs, air cleaner and PCV valve replaced. Has started and run fine since …
What is the sensor on a Jeep Grand Cherokee?
Most times it will restart on its own but lately it has taken longer to restart. The crankshaft position sensor, throttle position sensor, idle air control valve, coil, sparlk plugs, spark plug wires, distributor cap, rotor and cam shaft position sensor have all been changed or checked.
Why is my Jeep Grand Cherokee not working?
The cause of the issue was a short in the crankshaft position sensor that disabled all powertrain and braking systems. All systems share the same 5 volt circuit into pcm. See all problems of the 2011 Jeep Grand Cherokee . The contact owns a 2004 Jeep Grand Cherokee.
Are there any problems with the 2004 Jeep Grand Cherokee?
See all problems of the 2004 Jeep Grand Cherokee . Vehicle lost power while driving at speeds of 55mph. Check engine light and multiple system warnings were shown by evic, including abs, traction control, ignition system, 4wd system, and air suspension system. Braking power was severely diminished.
What’s the crankshaft position sensor on a Jeep Laredo?
Always use O.E.M. if you can afford it or plan to keep it. 1996 Jeep Grand Cherokee Laredo with the inline 4.0 six. 258000 miles. I had problems for years with the “Crankshaft Position Sensor,” crank no start.
What was the year of the Jeep Laredo?
1996 Jeep Grand Cherokee Laredo with the inline 4.0 six. 258000 miles. I had problems for years with the “Crankshaft Position Sensor,” crank no start. Had my mechanic replace and it would work for months and then again out of the blue “crank no start” again. Replaced and would be OK again for a while.
Is there a CPS failure on my Jeep?
BRAND NEW CPS FAILURE!!! Now that it took longer than I expected to finish building the Jeep, the F’n Return shipment date has passed.
What is the code for a bad crankshaft position sensor?
A diagnostic scan tool will show a code between P0335 and P0338. The check engine light doesn’t always come on, though, so you could be experiencing any of the above symptoms for some time before you see the warning light. There are a number of different problems that can cause similar symptoms to a crankshaft position sensor problem.