What is the camshaft sensor on a Jeep Cherokee?
Shop AutoZone for Jeep Cherokee Camshaft Position Sensor. Notes: Quantity per car: 2. Notes: Camshaft Synchronizer. 0.0 out of 5 stars. Notes: Includes sensor and oil pump drive. Engine camshaft synchronizer. 0.0 out of 5 stars. 0.0 out of 5 stars. 0.0 out of 5 stars.
Is the p0339 Cam and crankshaft sensor code?
Yes at an Authorized Jeep Dealership. They said the P0339 was the sensors code. They took it upon themselves to replace the cam and crankshaft sensors. Doing Solenoid because they suspect the timing is off…? v Lets get the details and gather info then get some info posted.
Are there any CAM and crankshaft sensor problems?
First time was with generic cam and crankshaft sensor parts. 2nd and Third time is with Mopar at the Chrysler dealership. Every mechanic thinks they have it fixed but immediately/or after a few miles the car dies again. It seems like they are having problems getting the sensors to stay programmed.
Is there a problem with the sensor on my Jeep?
Trouble codes log an issue and leed to a starting point–but. Replacement of the sensors requires the removal of the connector and manipulation of the wires. Connector pins-male-female bent/broken or wire to connectors broken,who knows.
Shop AutoZone for Jeep Cherokee Camshaft Position Sensor. Notes: Quantity per car: 2. Notes: Camshaft Synchronizer. 0.0 out of 5 stars. Notes: Includes sensor and oil pump drive. Engine camshaft synchronizer. 0.0 out of 5 stars. 0.0 out of 5 stars. 0.0 out of 5 stars.
What are the symptoms of a bad camshaft position sensor?
Symptoms of a Bad or Failing Camshaft Position Sensor. $79.99 – $89.99. Average rating from 4,829 customers who received a Check Engine Light is on Inspection. The camshaft position sensor gathers information about the vehicle’s camshaft speed and sends it to the vehicle’s engine control module (ECM).
Where do you put the compression tester in a jeep?
Put your finger into #1 cylinder or use a compression tester with a removable head (so all you have is the hose threaded into the #1 spark plug hole). Turn the engine over using a socket on the crank or alternator if the alternator is easier to reach.
Where is the CPS sensor located on a Jeep Wrangler?
Camshaft position sensor determines which cylinder is firing. Then it uses that information to sync the injectors with the ignition. The CPS is one of two sensors that if they fail, your Jeep will not fire the spark plugs or cycle the fuel injectors. Pretty much leaving your Jeep Wrangler or Cherokee sitting dead. Where is the CPS Sensor located?
Where is the camshaft on a Jeep YJ?
Rotate the engine either by hand until the pulse ring enters the magnetic pick-up on the camshaft position sensor. Rotor button should be pointing at about 8:30 – 9:00 o’clock position. Turn the ignition key to the “On” position. You should be reading approximately 5 volts.
How can I test my camshaft position sensor?
Test the sensor its self. To test the CPS you will need an analog (old school with the sweeping needle) voltmeter and small paper clips. Using the small paper clips, straighten and insert them into the backside of the distributor wiring harness connector.