What is T connector in bus topology?
T connectors are often used to connect the computer to the trunk cable. The T connector can connect the computer to two sections of cable with the bus extending in both directions. • The end devices on the bus have terminators on one connector of the T.
How is bus topology connected?
In a bus topology , all nodes in the network are connected directly to a central cable that runs up and down the network – this cable is known as the backbone . Data is sent up and down the backbone until it reaches the correct node.
Which type of connector is used to deploy bus network?
Bus networks typically use coaxial networking cable (it looks like the same coaxial cable used for cable television, but it is actually slightly different) hooked to each computer using a T-connector.
What cable does a bus network use?
Coaxial and fiber cables are the best cables to use in bus topology. They are also popularly enlisted by phone and internet providers for their communication abilities. So, what makes these cables so special? Since the 20th century, their improvements have made connection and communication increasingly efficient.
How many cables are needed in bus topology?
If N devices are connected to each other in a bus topology, then the number of cables required to connect them is 1, which is known as backbone cable, and N drop lines are required.
How is a bus network setup?
Bus topology refers to a network setup where nodes or devices are interconnected using a single cable. It is because of this setup why bus topology is often referred to as line topology or backbone. Bus topology is unidirectional and data is transferred from one end to another in a single direction.
How many computers can be connected in bus topology?
In a bus topology, only one host can transmit data at a time only when the bus is free. In a star network, data should pass through the central hub before reaching the receiver node.
What hardware is needed for a bus topology?
Computers and peripherals are called nodes and are each connected to a single cable on which data can be sent. A bus network topology has a terminator on each end. These are needed to ensure that the network functions correctly.